Intellinet 24-Port Gigabit Ethernet Desktop Switch User manual

Intellinet
Brand
Intellinet
Model
24-Port Gigabit Ethernet Desktop Switch
Category
Network switches
Type
User manual

This manual is also suitable for

INT-523530/523523-UM-0107-01
16/24-PORT
GIGABIT ETHERNET
DESKTOP SWITCH
USER MANUAL
MODEL 523530/523523
2
Thank you for purchasing this INTELLINET NETWORK SOLUTIONS
™
Gigabit Ethernet Desktop
Switch, Model 523530 (16-port) or Model 523523 (24-port).
With its 10/100/1000 Mbps gigabit ports, this switch easily boosts networking throughput,
providing a real gigabit connection that makes it possible to transfer large, high-bandwidth files
with greater speed and reliability. The store-and-forward architecture filters errors and forwards
packets in a non-blocking environment. Flow control ensures the correctness of data being
transmitted. And the 802.3x and back-pressure flow-control mechanisms work, respectively, for
full and half duplex modes.
The switch is designed for easy installation and maintenance. It supports NWay auto-negotiation
protocol that automatically detects the networking speed (10/100/1000 Mbps) and the
duplex modes (full/half). The Auto-MDI/MDI-X function alleviates the need to use crossover
cables, and rich diagnostic LEDs indicate real-time connection status.
Additional features include:
• Support of jumbo frames up to 9 kBytes
• Rugged metal housing for maximum durability
• Support of up to 8192 MAC address entries
• 19” rackmount brackets
• Lifetime Warranty
3
FCC STATEMENTS
FCC Warning
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful
interference, in which case the user will be required to correct the interference at his own expense.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: 1) This device may not cause harmful interference and 2) This device must accept
any interference received, including interference that may cause undesired operation.
CE Mark Warning
This equipment complies with the requirements relating to electromagnetic compatibility, EN 55022
class A for ITE, the essential protection requirement of Council Directive 89/336/EEC on the
approximation of the laws of the member states relating to electromagnetic compatibility.
4
FRONT PANEL
REAR PANEL
Power receptacle: Plug the female end of the power cord firmly into the receptacle and the
other end into an electrical outlet. Confirm that the power LED is lit for a normal power status.
Ports: All the ports on the Gigabit Ethernet Desktop Switch support Auto-MDI/MDI-X functionality.
• Crossover or straight-through cables can be used to connect to PCs, routers and other devices.
• Cat5/5e UTP/STP cables provide optimal performance.
System LED Status Operation
PWR Steady green Power on
Port LEDs Status Operation
1000M Steady green Valid port connection at 1000 Mbps
Blinking green Valid port connection; data being transmitted/received
Off Port disconnected or connected at 10/100 Mbps
10/100M Steady green Valid port connection at 10/100 Mbps
Blinking green Valid port connection; data being transmitted/received
Off Port disconnected or connected at 1000 Mbps
5
• The Auto-negotiation feature allows each port to operate in both half and full duplex mode at
10 Mbps and 100 Mbps; and at full duplex mode at 1000 Mbps.
INSTALLATION
Prior to use, it is recommended that the device be placed/positioned:
• with a minimum of 25 mm of clearance on the top and sides for adequate ventilation
• away from sources of electrical noise, such as radios, transmitters and broadband amplifiers
• where it cannot be affected by excessive moisture
Desktop:
1. Attach the included rubber feet to the bottom of the device to keep it from slipping. The
recommended positions are marked.
2. Place the device on a level surface that can support the weight of the switch (and any other
items that need to be considered).
Media Speed Recommended cable
10/100/1000 Mbps copper 10 Mbps Cat3/4/5 UTP/STP
100 Mbps Cat5 UTP/STP
1000 Mbps Cat5/5e UTP/STP
6
Rackmount:
1. Disconnect any cables from the switch before proceeding with rackmounting.
2. Place the device on a hard, flat surface with the front facing you.
3. Position one of the two included mounting brackets over the mounting holes on one side of the unit.
4. Insert the screws and fully tighten them with a suitable screwdriver.
5. Repeat the two previous steps for the other side of the device.
6. Insert the switch into the rack (secure with suitable screws, if desired); reconnect cables as needed.
SPECIFICATIONS
Standards & Certifications
• IEEE 802.3 (10Base-T Ethernet); IEEE 802.3u (100Base-TX Fast Ethernet); IEEE 802.3ab
(Twisted Pair Gigabit Ethernet); IEEE 802.3x (flow control, for full duplex mode)
• Certifications: FCC Class A, CE Mark, VCCI Class A, RoHS
General
• Media support: 10Base-T Cat3, 4, 5 UTP/STP RJ-45; 100Base-TX Cat5 UTP/STP RJ-45;
1000Base-T Cat5e UTP/STP RJ-45
• Packet filter/forwarding rates: 1,488,000 pps (1000 Mbps); 148,800 pps (100 Mbps);
14,880 pps (10 Mbps)
• Buffer memory: 340 kBytes for 16-port; 500 kBytes for 24-port
7
• MAC address table: 8192 entries
• Backplane speed: 32 Gbps for 16-port; 48 Gbps for 24-port
• Switch architecture: store and forward
LEDs
• Power
• Link/Act: 1000 Mbps, 10/100 Mbps
Power
• Internal power supply, 100 to 240 V AC, 50/60 Hz
• Power consumption: 14.4 Watts (maximum) for 16-port; 20.9 Watts (maximum) for 24-port
Environmental
• Metal housing, 1 U
• Dimensions: 266 (W) x 185 (L) x 44 (H) mm (10.4 x 7.3 x 1.7 in.); weight: 2.2 kg (4.9 lbs.)
• Operating temperature: 0 – 40°C (32 – 104°F); operating humidity: 10 – 90% RH, non-condensing
• Storage temperature: -10 – 70°C (-14 – 158°F)
Package Contents
• Gigabit Ethernet Desktop Switch
• Power cable
• Rackmount brackets (2) with screws
• User manual
Are you completely satisfied with this product?
Please contact your INTELLINET NETWORK SOLUTIONS
™
dealer
with comments or questions.
Copyright © INTELLINET NETWORK
SOLUTIONS
All products mentioned are trademarks or registered trademarks of their respective owners.
www.intellinet-network.com
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8

Intellinet 24-Port Gigabit Ethernet Desktop Switch User manual

Intellinet
Brand
Intellinet
Model
24-Port Gigabit Ethernet Desktop Switch
Category
Network switches
Type
User manual
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents