Feiss OL15402TXB Installation guide

Type
Installation guide

This manual is also suitable for

1
Installation Instructions for
CAUTION RISK OF FIRE-
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
1.0
OL15400-OL15401-OL15402-OL15403-OL15404
O 15400, O 15401, O 15402, O 15403, OL15404LLLL
Outdoor
1A
13
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing compliant junctionNEC
boxes.
This product is safety listed for wet locations.
Incandescent lamps may be dimmed with a standard incandescent dimmer.
LED LEDlamps may be dimmed with a dimmer. Consult lamp manufacturer
for additional information.
This instruction shows a typical installation.
Warren Outdoor Wall
For Models Ol15401, OL15402, OL15403, OL15404 Only: Temporarily install the mounting plate to the junction box and
mark the anchor hole locations through the mounting plate holes. Remove the mounting plate.
For Models Ol15401, OL15402, OL15403, OL15404 Only: Drill appropriate sized holes at the marked locations and install
the anchors.
Secure the mounting plate to the junction box.
For Models Ol15401, OL15402, OL15403, OL15404 Only: Screw the anchor screws into the anchors.
Attach the fixture arm to the fixture base and fixture loop with the provided screws.
Slide glass panels into the lower cover and secure each panel with clips.
Connect the fixture to a suitable ground in accordance with local electrical codes.
Connect the white fixture wire to the neutral power line wire with a wire nut.
Connect the black fixture wire to the hot power line wire with a wire nut.
Mount the fixture base onto the mounting plate and secure it with the fixture screws.
Screw the lamps into the sockets. Refer to the label on the socket for Max Wattage Information.
Install the lower cover to the top cover by using the cover screws.
For wet locations, caulk around the base of the fixture with waterproof construction sealant.
1
2
3
4
5
6
7
8
9
10
LAMP
11
FIXTURE
SCREW
9
MOUNTING
PLATE
9
8
7
3
5
TOP COVER
JUNCTION BOX
12
12
GLASS CLIP
GLASS PANEL
COVER SCREW
FIXTURE LOOP
FIXTURE ARM
FIXTURE
BASE
LOWER COVER
7
8
9
10
1011
1012
1013
5
SAVETHESE INSTRUCTIONS!
2
7400 Linder Ave, Skokie, 160077IL
800.969.3347
www.generationlighting.com
© 2019 Generation Lighting.All rights reserved.
The "Generation Lighting" graphic is a registered trademark of
Generation Lighting. Generation Lighting reserves the right to
change specifications for product improvements without notification.
  • Page 1 1
  • Page 2 2

Feiss OL15402TXB Installation guide

Type
Installation guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI