Questions about installation or product details? Contact our Tech Support team at 940-783-9914
STEP 1:
STEP 2:
STEP 3:
Using a no. 2 Phillips, back out the plastic screw
from the A-Pillar trim.
Remove Torx screws from the visor mounting brack-
et with the T20 Torx bit.
Pull upper visor trim down/off and then remove the
stock A-pillar. You should now have exposed the
corner frame of your Jeep where you can install the
custom gauge pod.
Part# 32306 works on: Jeep JK 2011+
Custom A-Pillar Pod
Installation Instructions
Pod Adapter
A-Pillar Pod
WHAT’S INCLUDED:
Questions about installation or product details? Contact our Tech Support team at 940-783-9914
32306-99_v1.2
STEP 4:
STEP 5:
STEP 6:
If installing another tuner
install the appropriate pod
adapter at this time. LWTS+
requires part # 30604 and
GTX requires part # 30605,
which is not included. Follow
instructions on installing the
located on the inside of the
packaging card. If you have
stock speakers be sure to
reconnect them at this time.
Install the custom gauge pod by guiding
the push pin into the appropriate hole and
pushing it into place. Secure it with the
remaining screw, install visor trim piece and
then reinstall visor.
Finish the installation by inserting the
plastic screws.
GT Head Unit
GT Custom Pod Adapter
Custom Gauge Pod
(To OBDII Adapter Plug)
Main Harness
Main Harness Plug
/