IR Remote/Receiver (For the Digital Amplifier PA2B)
PTN Electronics Limited www.PTN-electronics.com
Remote Controller
The IR remote has built in popular functions like Input Channels Selection, Mute and
Volume/EQ control.
The function description is showed as below:
Note: The battery of the remote controller is offered for charge. Please point the remote
controller at the IR receiver when use, to avoid getting out of control as there is no signal
detected.
IR Receiver
The IR receiver is used to receive the IR code from the remote controller. It connects to
PA2B by 3.5mm jack connector, and receives the IR codes by the IR receiver. The IR
receiver has an adhesive tape at the back that can be stick on the wall or ceiling. The IR
receiver cable is about 1.5m in length.
Please see the illustration below: