18
AQUATO
®
K-PILOT 18.1 / 18.3 / 18.4 Controller Operation Manual
Operation Manual AQUATO
®
K-Pilot 18.1/18.3/18.4
Page 18
5 Installation manual for the controller
5.1
Safety instructions
The controller is intended for wall mounting and is therefore pre-mounted on a
bracket. However, it can also be accommodated in a wall cabinet or an
outdoor cabinet.
Commissioning is carried out by connecting the controller to the mains.
Only plug in the power plug after the existing units have been connected to
the appropriate devices in the controller (see Chapter 6.2).
Only
allow qualified personnel to carry out the electrical installation. The
manufacturer accepts no liability for any damage caused as a result of
carrying out the installation on one's own.
Non-compliance with the following safety instructions may result in a limitation
or complete loss of liability on the part of the manufacturer.
Only specialists may perform any actions on the device or repairs of any kind.
Before commissioning and switching on the mains voltage, it must be ensured that:
• there is no visible damage to the device and the connection cables,
• in particular the mains connection and the connections of the units are properly connected,
• all connections have been made properly and professionally,
• the laying / routing of all cables and lines comply with the applicable regulations,
• the device is closed properly,
• the plant is properly secured.
Before working on the control console, please note the following important instructions:
• Disconnect the plant from the mains before opening the controller.
• To prevent tearing or damaging cables or hoses, open the control unit carefully and do not simply
drop the cover.
• Replace individual fuses only in a de-energized state.
• Never use fuses with currents higher than those specified.
• Do not manipulate the circuitry of the system in any way.
• The relevant applicable regulations (EN, VDE, etc.) as well as the regulations of local energy
suppliers must be strictly complied with.
• If a fuse is defective, it may only be replaced by a microfuse of the same type. In the standard
case with one compressor, a fuse of the following type is installed at the factory: microfuse, slow-
blow, type 3.15 A, 5 x 20 mm according to EN 60127-2/III with a maximum power loss of 1.5 W.