ROOMS TO GO 20453407 Assembly Instructions

I have reviewed the provided assembly instructions for the Console table 53402. This document details the steps for assembling the console table, including a parts list and hardware list, as well as instructions for aligning the table. I'm ready to answer any specific questions you have about assembling the furniture.
What is the first step of the assembly?

What should I do before fully tightening all bolts?

What hardware is included?

Assembly Instruction

Item No. 53402

PARTS LIST: HARDWARE LIST:

A

B

No. Sketch Description Size

Sketch

D

EAllen Bolt

Allen Key 1

8+1

STEP 1:

Thank you for purchasing this quality product. Be sure to

check all packing material carefully for small parts that may

have come loose inside the carton during shipment.

(Note: Loosely thread all screw/bolts first. Once the item is

assembled then completely tighten.)

C

STEP 2:

Quantity

No.

Quantity

1

2

1

INSERT PART B 1 IN PART A

INSERT PART C IN PART B1

B1 B2

0.16"

0.63"/0.24"

Tip B : Sometimes product will not line up because of an uneven

surface the furniture rests on. In that case try adjusting the

levelers found on the bottom of each leg to aid in correcting.

STEP 3:

STEP:4

D

E

TIPS FOR ALIGNING CONSOLE TABLE:

Place the top (A) on the flat surface and fix PART (B1) with

PART (C) and than fix PART (B2) - AS SHOWN.

Make sure everything is on the floor.

NOTE: Do not fully tighten all bolts during assembly then

assembly fully tighten all bolts.

INSERT PART B2 IN PART

C AND A

/

Other documents