Axxess AXDI-A12 Installation guide

Category
Car kits
Type
Installation guide
AXDI-A12
INSTALLATION INSTRUCTIONS
AxxessInterfaces.com © COPYRIGHT 2023 METRA ELECTRONICS CORPORATION REV. 8/2/23 INSTAXDI-A12
ATTENTION:
With the key out of the
ignition, disconnect the negative battery
terminal before installing this product.
Ensure that all installation connections,
especially the air bag indicator lights, are
plugged in before reconnecting the battery
or cycling the ignition to test this product.
NOTE: Refer also to the instructions included
with the aftermarket accessory before
installing this device.
INTERFACE FEATURES
INTERFACE COMPONENTS
TOOLS & INSTALLATION ACCESSORIES REQUIRED
• Crimping tool and connectors, or solder gun,
solder, and heat shrink • Tape • Wire cutter
• Zip-ties
TABLE OF CONTENTS
Connections ........................................................ 2-3
LD-AX-XSVI-AU1 Diagram .................................2
LD-AX-XSVI-AU2 Diagram ................................ 3
Installation .............................................................4
Programming .........................................................4
Audi Data Interface 2002-2013
• Provides accessory power (12-volt 10-amp)
• Retains R.A.P. (Retained Accessory Power)
Provides wires for multimedia radios (park brake, reverse, speed sense)
• Prewired AXSWC harness (AXSWC sold separately)
• Retains balance and fade
• Micro-B USB updatable
• AXDI-A12 interface
• LD-AX-XSVI-AU1 harness
• LD-AX-XSVI-AU2 harness
APPLICATIONS
LD-AX-XSVI-AU1 Harness:
A3 (1) ............................................... 2006-2013
A4/RS 4/S4 (with NAV) .................2005-2008
A4/RS 4/S4 ..................................... 2007-2008
A4/RS 4/S4 ...............................................2006
TT ......................................................2008-2013
LD-AX-XSVI-AU2 Harness:
A3 (2) ..............................................2006-2007
A4/S4 (3) ........................................2002-2006
A6 ..............................................................2004
Allroad ............................................2004-2005
TT ..................................................... 2002-2006
(1) With either Symphony Plus or NAV radio.
(2) With Concert radio (without NAV)
(3) With Symphony radio (without NAV)
Visit AxxessInterfaces.com
for more detailed information about the product
and up-to-date vehicle specific applications
2
CONNECTIONS: LD-AX-XSVI-AU1 DIAGRAM
12-Pin
AUX-IN Rear View
SWC
Aftermarket Radio
Front Rear
Sub
Vehicle Connectors
Fuse Holder
Radio Connections
SWC Harness
Steering Wheel
Control (AXSWC)
(Sold Separately)
LD-AX-XSVI-AU1
Interface
RCAs
Blue/White - Amp turn on
Blue/Pink - VSS/Speed-Sense
Orange - Illumination
Green/Purple - Reverse signal
Light Green - Parking brake
Gray - Front right speaker +
Gray/Black - Front right speaker -
White - Front left speaker +
White/Black - Front left speaker -
Red - Accessory power
Black - Ground wire
Yellow - Battery wire
Green - Rear left speaker + output
Green/Black - Rear left - speaker output
Purple - Rear right + speaker output
Purple/Black - Rear right - output
Blue - Antenna turn on
(Your radio’s features may vary)
White RCA Jack – Front left output
Gray RCA Jack – Front right output
Green RCA Jack – Rear left output
Purple RCA Jack – Rear right output
3
REV. 8/2/23 INSTAXDI-A12
CONNECTIONS: LD-AX-XSVI-AU2 DIAGRAM
12-Pin
AUX-IN Rear View
SWC
Aftermarket Radio
Front Rear
Sub
Vehicle Connectors
Fuse Holder
Radio Connections
SWC Harness
Steering Wheel
Control (AXSWC)
(Sold Separately)
Interface
RCAs
Blue/White - Amp turn on
Blue/Pink - VSS/Speed-Sense
Orange - Illumination
Gray - Front right speaker +
Gray/Black - Front right speaker -
White - Front left speaker +
White/Black - Front left speaker -
Red - Accessory power
Yellow - Battery wire
Black - Ground wire
Green - Rear left speaker + output
Green - Rear left speaker + output
Green/Black - Rear left - speaker output
Light Green - Parking brake
Purple - Rear right + speaker output
Purple/Black - Rear right - output
(Your radio’s features may vary)
LD-AX-XSVI-AU2
RCAs
White RCA Jack – Front left output
Gray RCA Jack – Front right output
Green RCA Jack – Rear left output
Purple RCA Jack – Rear right output
KNOWLEDGE IS POWER
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.edu or call
386-672-5771 for more information and take steps
toward a better tomorrow.
®
Metra recommends MECP
certified technicians
AxxessInterfaces.com © COPYRIGHT 2023 METRA ELECTRONICS CORPORATION REV. 8/2/23 INSTAXDI-A12
INSTALLATION INSTRUCTIONS
AXDI-A12
Having difficulties? We’re here to help.
Contact our Tech Support line at:
386-257-1187
Or via email at:
Tech Support Hours (Eastern Standard Time)
Monday - Friday: 9:00 AM - 7:00 PM
Saturday: 10:00 AM - 5:00 PM
Sunday: 10:00 AM - 4:00 PM
I N S TAL L ATI O N
PROGRAMMING
With the key in the off position:
Connect the LD-AX-XSVI-AU1 or LD-AX-XSVI-AU2 harness into the interface, and then to
the wiring harness in the vehicle.
Attention! If the interface loses power for any reason, the following steps will need to be performed again. Also, if installing an
AXSWC connect it after you initialize and test the interface/radio, with the key in the off position.
Turn the key (or push-to-start button) to the ignition position and wait until the radio comes on.
Note: If the radio does not come on within 60 seconds, turn the key to the off position, disconnect the interface, check all
connections, reconnect the interface, and then try again.
Turn the key to the off position, and then to the accessory position. Test all functions of the installation for proper operation,
before reassembling the dash.
Note: If using the AXSWC, connect it after you initialize the AXDI-A12, with the key in the off position.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Axxess AXDI-A12 Installation guide

Category
Car kits
Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI