Gleason Reel Power Bar Installation guide

Gleason Reel
Brand
Gleason Reel
Model
Power Bar
Type
Installation guide
Installing POWER BAR/MOUNTING BAR Assembly
A1. Power Bar and Mounting Bar are factory assembled. If Power
Bar and Mounting Bar have not been pre-assembled, or if
Power Bar needs side-to-side adjustment on mounting bar,
follow steps B1 – B3 at right.
A2. Mount assembly to workstation. Loosen track nuts on Hanger
Plates so that they will slide into column from top. (Fig. 2)
NOTE: It may be necessary to first remove workstation
components mounted above desired location of Power Bar.
A3. Position assembly as desired and tighten track nuts. Replace
components removed in step A2.
A4. Plug cord into suitable 120v outlet.
Installing POWER BAR to existing Bin Bar.
B1. Remove backing from rubber bumpers and affix to back of Power
Bar directly behind electrical receptacles and mounting brackets.
Refer to Figure 1–General Arrangement.
B2. Position Power Bar in Bin Bar recess.
B3. Loosen lock nuts on mounting brackets and slide hooks out
(Fig.3 & 4). Position brackets over Power Bar. Slide hooks in to
hold assembly in place on Bin Bar. Tighten locknuts.
B4. If necessary, reposition Bin Bar on workstation by loosening track
nuts and sliding bar. Tighten track nuts, clamping bar in place.
B5. Plug cord into suitable 120v outlet.
MOUNTING BAR
(Bin Bar)
HANGER PLATE WITH
TRAK NUTS
Mounts Bin Bar to
upright column
LEAD CORD WITH
PLUG
RUBBER
BUMPERS
MOUNTING BRACKET
Affixes Power Bar to Bin Bar.
See details below.
POWER BAR
15 Amp
125 Volt
60 Hz.
GROUNDED
OUTLETS
HOOK
FRONT
HOOK
BRACKET
BRACKET
BUMPER
LOCKNUT
MOUNTING BAR TRACK NUT
HANGER
PLATE
POWER
BAR POWER
BAR
BIN
BAR
BIN
BAR
VERTICAL
COLUMNS
POWER BAR/MOUNTING BAR
ASSEMBLY
ON/OFF
SWITCH
RESET
SWITCH
OPTIONAL THIRD
MOUNTING BRACKET
#WPB-MK
Figure 3-End View
Figure 1–General Arrangement
Figure 4-Bracket Detail
Figure 2-Support Bar Installation
1
2
INTRODUCTION: Power Bar mounts to C-Rail commonly used on workstations. The power bar is available with mounting bar
or separately for attachment to an existing Bin Bar.
INSTALLATION INSTRUCTIONS
POWER BAR for WORKSTATIONS
Printed in USA Bulletin No. 630165.b
HUBBELL
®
Workplace Solutions
600 South Clark St.
Mayville, WI 53050
Phone 920–387–4120
  • Page 1 1

Gleason Reel Power Bar Installation guide

Gleason Reel
Brand
Gleason Reel
Model
Power Bar
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents