Figure 3
Left cover support
1. Drill surfaces 3. Mark and drill 0.234 inch
diameter hole here
2. Frame edge 4. Mark line
3. Drill a 15/64 inc h diameter hole a the mark ed
location.
Important: T ak e caution not to dama ge
an y inter nal machine components dir ectl y
behind the mar k ed location when drilling
the holes.
4. Scribe a line through the drilled hole , parallel
to the bottom edg e and along the side of the
control panel frame .
5. Using the left side co v er suppor t as a template
( Figure 4 ), align the upper , forw ard hole with
the hole drilled in ste p 3 .
6. Inser t a screw to in the upper , forw ard hole of
the co v er and rotate the co v er until the rear ,
upper hole sho ws the line scribed previously
( Figure 4 ). Mark the location of the upper , rear
hole and mark the location of the lo w er hole
in the co v er .
Figure 4
Left cover support
1. Left side cover 4. Mark rear hole here
2. Drilled hole 5. Bolt, 1/4 x 3/4 inch
3. Mark lower hole here
7. R emo v e the co v er and fastener . Drill tw o
15/64 inc h diameter holes in the locations
mark ed.
Important: T ak e caution not to dama ge
an y inter nal machine components dir ectl y
behind the mar k ed location when drilling
the holes.
8. Install the co v er using 3 bolts (1/4 x 3/4 inc h)
located in loose par ts ( Figure 4 ).
9. T o install the right rear co v er , re peat this
procedure on the opposite side of the mac hine
with the remaining co v er .
3
