2. Rugged Ridge
  3. 13462.01

Rugged Ridge 13462.01, 13462.04, 13462.07, 13462.09, 13462.15, 13462.37, Fold & Tumble Vinyl Rear Seat Installation guide

  • Hello! I am an AI assistant that has reviewed the installation instructions for the Rugged Ridge Fold & Tumble Seat for CJ and YJ vehicles from 1976-1995. This document details how to install the front seat brackets, use the C-clips, and install the rear seat lock including some steps that requires drilling additional holes. I am ready to answer your questions about this process.
  • What type of vehicles are these seats designed for?
    Are additional materials needed for the installation?
    What is the purpose of the C-clip?
    What should be checked before fully tightening the seat belt anchor bolt?
Installation Instructions: Fold & Tumble Sear Seat (1976-1995) CJ - YJ
(Step 1 – Fig. A) Front Seat Brackets.
Remove seat mounting bolts from floor. Please note that some early CJ models
may only have one mounting hole for each side. Drilling of the second mounting
hole will be required (additional hardware supplied by customer). Grade 5 or
higher bolt and large washer are recommended.
Install front seat brackets through seat mounting tabs as shown. Install C-clip to
secure bracket to tab. Align mounting bracket over holes in floor and securely
tighten with seat mounting bolts.
(Step2 – Fig.B) Rear Seat Lock
Remove seat belt anchor bolt from floor. Position lock underneath seat belt &
eyelets as shown in (Feg.B). Please note that more than one hole is supplied to
align the bracket with the floor mounting hole and seat lock. If desired an additional
hole can be drilled and the bracket secured with two bolts. Grade 5 or higher bolt
and large washer is recommended (supplied by customer). Reinstall seat belt anchor bolt
through seat belt eyelets and seat lock. DO NOT TIGHTEN YET.
Align seat lock with striker so that seat locks when the seat is pushed down into
position. Tighten seat belt anchor bolt. At this time a second hole, if desired,
can be drilled and additional hardware added (supplied by customer).
/