ESPEN VRF-DR User manual

Brand: ESPEN

Model: VRF-DR

Type: User manual

ESPEN VRF-DR is a wireless remote control device that allows you to control your lighting system with ease. With a range of up to 25 meters, you can adjust the brightness, color temperature, and power of your lights from anywhere in the room. It also features a built-in wireless charger, so you can keep it powered up without having to worry about tangled cords.

User Manual

Model：VRF-DR

Remote Control

About the use of remote control lamp

instructions and operating procedures：

1.2.4G part of the code, remote control distance of

twenty-five meters. Every keystroke operation,

LED signal two (right) will flicker.

2.At the same time, press and hold the power

button ON and the brightness + button to turn

ON the power, and the light will automatically

blink five times. The code matching is successful.

3.According to the identification on the remote

control:

K1. Represents the switch light key,

K2. Represents the brightness of the lamp +,

K3. Pinhole represents the CCT color key,

K4. Represents the brightness of the lamp -,

K5. Represents the light off key.

4.Decoding: press and hold the on and CCT keys

simultaneously for five seconds, the light will flash

seven times, and the decoding is successful.

5.Wireless charging part

When the remote control is placed on the

charger, the remote control will automatically

charge. LED signal one (left) will flash to

indicate charging.

Charging current：0.1-50mA

Battery capacity： 70-90mA

Charging voltage：3.8-4.5V

Ambient temperature：-10 ~ 55℃

Wireless frequency：2426 - 2470MHz

Modulation mode：GFSK

Antenna gain：0 dBi

The rest of the hardware is based on specifications

and physical objects.

FCC Statement：

Any Changes or modifications not expressly approved by the party responsible for compliance could

void the user’s authority to operate the equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference that may cause undesired

operation.

FCC Radiation Exposure:

The device has been evaluated to meet general RF exposure requirement . The device can be used in

portable exposure condition without restriction.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment generates uses and can radiate radio

frequency energy and, if not installed and used in accordance with the instructions, may cause harmful

interference to radio communications. However,there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or television reception, which

can be determined by turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

—Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and receiver.

—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

—Consult the dealer or an experienced radio/TV technician for help.

ESPEN VRF-DR User manual

ESPEN VRF-DR User manual

Other documents