ADTRAN 1442704PG2 Datasheet

Brand: ADTRAN

Model: 1442704PG2

Category: Network transceiver modules

Type: Datasheet

jobAid

DESCRIPTION

TheSmallForm‐FactorPluggableOC‐12Bidirectional1550/1310

nm(BidirectionalSFP)plugsintoADTRANequipmentdesigned

toacceptSmallForm‐factorPluggables(SFPs).Installedintoan

appropriatehostunit,theBidirectionalSFPprovidesanOC‐12

interfacetothesupportingsystem.

NOTE

Toensurecompatibility,refertothedocumentationprovi ded

withthehostmodule.

ThefollowingfeaturesaresupportedontheBidirectionalSFP:

♦ SONETOC‐12compatible(622Mb/s),single‐fiberoperation

♦ 15kmmaximumopticalspan

CAUTION

Duetocompliancecertificationrequirements,onlySFPssupplied

byADTRANaretobeusedwiththehostmodule.ADTRAN

cannotcertifysystemintegritywithotherSFPs.

SPECIFICATIONS

♦ OpticalSpecifications:

◊ Opticaltransmitlevel:–8dBmto–15dBm

◊ Opticalreceivelevel:–8dBmto–28dBm

◊ TransmitWavelength:1550nm

◊ ReceiveWavelength:1310nm

◊ Opticalbudget:12(±1)dBm

◊ Opticalconnectors:LC

Small Form-Factor Pluggable OC-12

Bidirectional 1550/1310 nm

♦ ExtendedEnvironmentalSupport:

◊ Operationaltemperaturerange:–40°Cto+65°C

◊ Storagetemperaturerange:–40°Cto+85°C

◊ Relativehumidityto95%,noncondensing

INSTALLATION

ToinstalltheBidirectionalSFPintoanappropriatemodule,

completethefollowingsteps:

1. InspecttheBidirectionalSFP.Ifdamaged,fileaclaimwith

thecarrierandthencontactADTRANCustomerSupport.

CAUTION

DonotremovetheprotectiveendcapfromtheSFPuntilthefiber

opticcableisreadytobeconnected.

2. InserttheBidirectionalSFPintotheSFPcageonthemodule.

Ensurethatthemanufacturer’slabelontheSFPisfacing

upwardforcorrectinstallation.

3. SlidetheBidirectionalSFPallthewayintothereceptacle

untilthereisanaudible“click”.

NOTE

ThelatchontheSFPisusedtoremovetheSFPfromthecageon

thecircuitcard.

SAFETY AND REGULATORY COMPLIANCE

CAUTION

♦ ElectrostaticDischarge(ESD)candamageelectronicmodules.

Whenhandlingmodules,wearanan ti st ati c dischargewrist

straptoprevent damageto el ectronic components.Place

modulesinantistaticpackingmaterialwhentra nsportingor

storing.Whenworkingonmodules,alwaysplacethemonan

approvedantistaticmatthatiselectricallygrounded.

♦ TheSFPmeetsorexceedsalltheapplicablerequirementsof

NEBS,TelcordiaGR‐63‐CORE,GR‐10 89 ‐CORE,andETSIEN

300368.TheBidirectionalSFPisintendedfordeploymentin

CentralOfficetypefacilities,EEEs,EECs,andlocationswhere

theNECapplies(forexample,CustomerPremises).TheSFPis

tobeinstalledin

ADTRANproductsinRestrictedAc cess

Locationsonly,andinstalledbytrainedservicepersonnel.

ThisdevicecomplieswithPart15oftheFCCrules.Operationis

subjecttothefollowingtwoconditions:

1. Thisdevicemaynotcauseharmfulinterference

2. Thisdevicemustacceptanyinterferencereceived,including

interferencethatmaycauseundesiredoperation.

Changesormodificationsnotexpresslyapproved

byADTRAN

couldvoidtheuserʹsauthoritytooperatethisequipment.

CLEI: S00TALBJ__

Product P/N: 1442704PG2

Issue Date: October 2010

Document P/N: 61442704PG2-22A

C A U T I O N

SUBJECT TO ELECTROSTATIC DAMAGE

OR DECREASE IN RELIABILITY.

HANDLING PRECAUTIONS REQUIRED.

Warranty: ADTRAN will replace or repair this product within the warranty period if it does not

meet its published specifications or fails while in service. Warranty information can

be found online at www.adtran.com/warranty

ADTRAN CUSTOMER CARE:

From within the U.S. 1.800.726.8663

From outside the U.S. +1 256.963.8716

PRICING AND AVAILABILITY 1.800.827.0807

*61442704PG2-22A*

CAUTION

♦ PerGR‐1089‐COREtheADTRANsystemthattheSFPisbeing

deployed inisdesignedandintendedforinstallationaspartof

aCommonBondingNetwork(CBN).TheADTRANsystem

thattheSFPisbeingdeployedinisnotdesignednorintended

forinstallationaspartofanIsolatedBondingNetwork(IBN).

♦ PerGR‐10 89‐CORESection9, theBidirectionalSFPdoesnot

haveaninternalDCconnectionbetweenbatteryreturnand

frameground.TheBidirectionalSFPcanbeinstalledinaDC‐I

(isolated)orDC‐C(common)installation.Forinstallations

whereothercardsorthehostsystemhaveinternalconnections

betweenbatteryreturn

andframeground,thesystemwould

beintendedfordeploymentonlyinaDC‐Cinstallation.

♦ TheADTRANsystemchassisframegroundterminalmustbe

connectedtoareliableearthgroundtoens urethatthemetal

enclosureoftheBidirectionalSFPisproperlygroundedviathe

backplaneconnector.

CAUTION

TheSmallForm‐FactorPluggableOC‐12Bidirectional1550/1310

nmisaClass1LaserProductandcomplieswiththeLaserSafety

requirementsofFDA21CFR1040.11,EN60825‐1,andEN60825‐2.

TheBidirectionalSFPisNRTLListedandCBCertifiedtoall

applicableAmericanandEuropeansafetystandards.

NOTE

TheGigabitEthernetport(s)areopticalandthereforearenot

classifiedasanytypeofportasdefine dinAppendixBof GR‐

1089‐COREIssue5.

TheBidirectionalSFPisdesignedtomeetthefollowingenviron‐

mentalclasses:

♦ ETSIEN300019‐1‐1“Classificationofenvironmental

conditions;Storage,”Class1.2

♦ ETSIEN300019‐1‐2“Classificationofenvironmental

conditions;Transportation,”Class2.3

♦ ETSIEN300019‐1‐3“Classificationofenvironmental

conditions;Stationaryuseatweather‐protectedlocations,”

Class3.3

Theequipmentisdesignedtofunctionwithoutdegradation

duringexposuretoalltestseveritiesperClass3.3.

TheSmallForm‐FactorPluggableOC‐12Bidirectional1550/1310

nmmeetsEURoHSDirective2002/95/ECand/orapplicable



exemptions.Refertowww.adtran.com

forfurtherinformationon

RoHS/WEEE.

NOTE

♦ ThisBidirectionalSFPiscompliantwithSFF‐8472“Digital

DiagnosticsMonitoringInterfaceforOpticalTransceivers,”

Revision9.3.

♦ ThisBidirectionalSFPiscompliantwiththeSmallForm‐Factor

Pluggable(SFP)Multi‐SourceAgreement(MSA).

♦ ThisBidirectionalSFPisdesignedtobe deployedinGR‐3108‐

COREenvironmentalclass1or2asdefinedinGR‐3108‐CORE

Issue2.

ADTRAN 1442704PG2 Datasheet

Brand: ADTRAN

Model: 1442704PG2

Category: Network transceiver modules

Type: Datasheet

Download PDF

report

ADTRAN 1442704PG2 Datasheet

ADTRAN 1442704PG2 Datasheet

Related papers

Other documents