Page is loading ...
ENG
Connecting to the External Devices
(depending on the model)
Rear of the TV
(Input/Output)
①
This end can be fitted with:
◆ Three RCA connectors (VIDEO + AUDIO-L and R)
◆ An S-Video connector and two audio RCA connectors (L+R); AV-1, AV-2
②
If you have a second VCR and wish to copy cassettes tape, connect the source VCR to
“AV-1”
and the
target VCR to
“MONITOR OUT”
so that you can redirect the signal from
source VCR
to target VCR.
③
If you have a decoder, connect the decoder to the VCR and the VCR to the television.
➃
“MONITOR OUT” is used for displaying the current picture to an external device.
When you wish to
record the current picture, connect the VCR to
“MONITOR OUT”
.
①
Side of the TV
(Input)
Camcorder
Video disc player
Video game device
or
VCR
Decoder /
Video game device
Video disc player
Satellite receiver
③
➃
②
ENG
Connecting to the S-Video Input
(depending on the model)
The “S-VIDEO” and RCA (AUDIO-L/R) connectors are used for equipment with an S-Video output, such as
a camcorder or VCR.
Side of the TV
Camcorder
VCR
and
Rear of the TV
and
①
To play pictures and sound, both the S-VIDEO and RCA connectors must be used.
①
ENG
The “AUDIO OUT” connectors are used for equipment, such as an audio system or external amplifier
(to take full advantage of the Surround sound effect).
Audio System/
External Amplifier
Connecting to the Audio Outputs
Rear of the TV
ENG
Connecting to the Component Input
①
The “COMPONENT 1” connectors are used for equipment with a DVD output.
(480i, 480p, 576i, 576p, 720p,1080i)
②
The “COMPONENT 2” connectors are used for DTV receiver. (480p, 576p, 720p, 1080i)
DVD
Rear of the TV
DTV receiver
①
②
ENG
Connecting to the DVI Input (depending on the model)
The DVI IN and RCA (AUDIO-L/R) connectors are used for equipment with a DVI output.
and
Rear of the TV
DTV receiver
Personal Computer
ENG
Connecting to the PC Input
The “PC IN” and “AUDIO-L/R” (PC IN-RCA) connectors are
used for interfacing with your PC.
Personal Computer
and
Setting up Your PC Software (Windows only)
The Windows display-settings for a typical computer are shown below. But the actual screens on your PC will
probably be different, depending upon your particular version of Windows and your particular video card.
But even if your actual screens look different, the same, basic set-up information will apply in almost all cases.
(If not, contact your computer manufacturer or Samsung Dealer.)
First, click on Settings on the Windows start menu.
While
Settings is highlighted, move the cursor so that Control
Panel
is highlighted.
When the control panel screen appears, click on
Display and a
display dialog-box will appear.
Navigate to the
Settings tab on the display dialog-box.
The correct setting of size (resolution) is
1024 x 768 pixels.
If a vertical-frequency option exists on your display settings
dialog box, the correct value is
60 Hz. Otherwise, just click OK
and exit the dialog box.
Rear of the TV
①
①
①
The “PC OUT” and “AUDIO-L/R” (PC OUT-RCA) connectors are used for some other computer
device, such as a multi-media PC monitor.
ENG
PC Input Mode
Notes
◆ When this television is used as a PC display, 32-bit color is supported (over 16 million colors).
◆ Your PC display screen might appear different depending on the manufacturer (and your particular version of
Windows). Check your PC instruction book for information about connecting your PC to a television.
◆ If a vertical and horizontal frequency-select mode exists, select 60Hz (vertical) and 31.5kHz (horizontal).
In some cases, abnormal signals (such as stripes) might appear on the screen when the PC power is turned
off (or if the PC is disconnected). If so, press the
SOURCE () button to enter the Video mode. Also, make
sure that the PC is connected.
◆ When horizontal synchronous signals seem irregular in PC mode, check PC power saving mode or cable
connections.
◆ Same modes as PC are supported for the signal input to the DVI jack. Only a separate sync signal is
supported.
◆ The interlace mode is not supported.
◆ The television might operate abnormally if a non-standard video format is selected.
Both screen position and size will vary depending on the type of PC monitor and its resolution.
The table below shows all of the display modes that are supported:
Mode
VGA
SVGA
XGA
Resolution
640 x 480
640 x 480
800 x 600
800 x 600
1024 x 768
1024 x 768
Vertical frequency (Hz)
60.00
75.00
60.00
75.00
60.00
75.00
/
