GMC Savana Owner Manual (GMNA-Localizing-U.S./Canada-13882574) -
2020 - CRC - 6/17/19
12 Keys, Doors, and Windows
vehicle's heating or air conditioning
systems. See Climate Control
Systems 0 145.
Laws in some local communities
may restrict the use of remote
starters. For example, some laws
may require a person using remote
start to have the vehicle in view
when doing so. Check local
regulations for any requirements on
remote starting of vehicles.
Do not use the remote start feature
if the vehicle is low on fuel. The
vehicle may run out of fuel.
The RKE transmitter range may be
less while the vehicle is running.
Other conditions can affect the
performance of the transmitter, see
Remote Keyless Entry (RKE)
System 0 9.
/ : This button will be on the RKE
transmitter if the vehicle has remote
start.
To start the engine using the remote
start feature:
1. Aim the RKE transmitter at the
vehicle.
2. Press and release
Q on the
transmitter.
3. Immediately press and hold
/
until the turn signal lamps
flash. If you cannot see the
lamps, press and hold
/ for at
least four seconds.
When the engine starts, the
parking lamps will turn on and
remain on while the engine is
running. The doors will be
locked.
The engine will continue to run
for 10 minutes. After
30 seconds, repeat the steps if
a 10-minute extension is
desired. Remote start can be
extended only once.
After entering the vehicle during a
remote start, turn the ignition on to
drive the vehicle.
A maximum of two remote starts or
a start with an extension are
allowed between ignition cycles.
If the remote start procedure is used
again before the first 10-minute time
frame has ended, the first
10 minutes will immediately expire
and the second 10-minute time
frame will start.
After the engine has been remote
started two times, or a remote start
with an extension, the ignition must
be turned on and then off before the
remote start procedure can be used
again.
To cancel a remote start do any of
the following:
.
Aim the RKE transmitter at the
vehicle and press
/ until the
parking lamps turn off.
.
Turn on the hazard warning
flashers.
.
Turn the ignition on and then off.
The remote vehicle start feature will
not operate if:
.
The key is in the ignition.
.
The hood is open.
.
The hazard warning flashers
are on.