Abtus AV544 User manual

Abtus
Brand
Abtus
Model
AV544
Category
Flat panel wall mounts
Type
User manual
LCD/LED Display
W
all Mount
Model: AV544
SPECIFICATION
* Specifications are subject to changes without notice.
ABtUS SINGAPORE PTE LTD
www.abtussingapore.com
** For detail, updated Command Code and Application Software, please visit and download from www.abtussingapore.com
DIMENSION OVERVIEW
mm inch
A 230 9.06”
B 50-200 1.97”-7.87”
C 50-200 1.97”-7.87”
D 230 9.06”
E 110 4.33”
F 115 4.53”
Model Name A
V544
LCD/LED SIZE Suitable for 17” to 32”
GROSS DIMENSION 250 x 250 x 25 (mm)
GROSS WEIGHT 950 g
VESA MOUNTING HOLES 50 x 200 Max
DISTANCE FROM WALL 15 mm
LOAD CAPACITY 20 Kgs
COLOUR OPTION Black
User Operation Guide
INSTALLATION
1). Do not over tighten screws during inst
allation. Over tightening can cause damage to the
screws and greatly reduce their ability to support the weight of the display.
2). Ensure that the mounting screws are anchored to the center of studs. Use of
an “edge to edge” stude finder is highly recommended.
Step 1:
Drill holes onto the wall and put 8x40 Concrete anchor
(E)
in the holes. Fit the wall board to the wall using ST5X40
Lag bolt (D) as above / right fig.
Keep the bubble level aline.
Step 2: Mounting the TV set to the TV board
Using A-C bolt packed in accessories package, mount the screen to the TV board.
Put in the screws (A-C), then fix them to the TV mounting holes as shown below.
Step 3: Putting the wall mounted
TV board
with screen to the wall board
Hand the TV set mounted on the TV board (G) to the
wall board (F). Please see as right fig.
PACKAGING CONTENT
1). Do not begin the inst
allation of this product until you have read and fully understood the instructions
and warnings contained in this installation sheet. If you have any questions regarding any of the instruction
or warning, please contact your local distributor.
2). Please refer to the manufacturer’s installation guide on recommendation for required distance from
the wall to avoid risk of property damage.
3) This product should only be installed by someone when good mechanical knowledge.
4). Make sure that the supporting surface can safely support the combined load of the equipment and all
attached hardware an components.
5). Never exceed the Maximum Local Capacity.
6). When mounting onto wooden wall studs, ensure that mounting screws are anchored into the center
of the studs Use of an “edge to edge” stud finder is highly recommended.
7). This product intended for indoor use only. Installing this product outdoors could lead to product failure
and personal injury.
WARNING
Item
A Bolt M5x16 4 set
s
C Bolt M8x16 4 sets
Item
D Lag bolt S
t5x40 3 sets
Item
E Concrete anchor 8x40 3 set
s
Item
F W
all Mount 1 set
Item
G TV Bracket 1 set
* Specifications are subject to changes without notice.
** For detail, updated Command Code and Application Software, please visit and download from www.abtussingapore.com
  • Page 1 1
  • Page 2 2

Abtus AV544 User manual

Abtus
Brand
Abtus
Model
AV544
Category
Flat panel wall mounts
Type
User manual
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents