Page 01
1
Installation
Mizu Drift 40mm Plug & Wastes -
Non-Overflow and Overflow
98°
98°
184 19
117
114
ASM X0
2
Designer
Proofread
Verify
Authorized
Page 1;Total Pages 1
Description
Item Code
Material Edition
Theory Weight[g]
Theory Area[cm ]
Theory External Area[cm ]
Drawing Unit mm
Scale 1:2
Marking Revised Content Design Date
Basin Mixer
133932504RECE-ABC
FHB 18.09.03
LLJ 18.09.03
T F 18.09.03
PBY 18.09.03
Drawing Angle
Useful Measurement
Key Measurement
Measurement Tolerance Value (Not Marked) Angle Tolerance Value (Not Marked)
Basic Measurement 0＜a≤6 6＜a≤30 30＜a≤120 120＜a≤400
`0.5 ~
Tolerance Value `0.1 `0.2 `0.3 `0.5
1. Apply a thin bead of non acetic silicone around the outlet hole opening of the basin.
2. Fit the waste body into the hole, if waste has an overflow ensure slotted section of the waste is pointed towards the
oveflow slot of the basin.
3. Underneath the basin, apply the silicone based sealing washer onto the thread then place and screw backing nut
onto the waste body and firmly tighten.
4. Do not over tighten on ceramic basins.
5. Allow sufficient time for the silicone to cure.
6. Fit the waste trap and check for any leaks.
7. Ensure there is no silicone residue left on surface of waste.
Published 06/06/2023
We recommend the use of soapy water or approved cleaners. This product should not be cleaned with abrasive materials. Damage caused by
any improper treatment is not covered by the product warranty. Refer to Warranty Conditions
Plumbers, please ensure a copy of the installation
instruction is left with the end user for future reference.
Mizu Drift Plug & Wastes - Non-Overflow and Overflow
of 01
Mizu - Drift 40mm Plug & Waste - Non-Overflow & Overflow
/
