Byron 62570 Owner's manual

Brand: Byron

Model: 62570

Type: Owner's manual

™

CH Byron, Byron House, Sherwood Rd

Astonfields, Bromsgrove, B60 3DR, UK

[email protected]

9-5 Mon-Fri, Local call charges apply

Tel: 0845 2301231 (UK) www.chbyron.com

Traditional Wired Door Chime

Drill Template for Key Hole Mounting Slots

Installation guide:

Using the template provided, drill two appropriate sized holes to

accommodate the wall plugs. When tightening the screws leave

approximately 10mm of the screw proud.

Connector Block

Terminals

Transformer Operation: Two Wire Installation (standard)

Commonly used when upgrading a previous installations:

1: Connect one of the wires (Bell Push Or Transformer) to terminal 2 of the

chime connector block.

2: Connect the second wire from the bell push to terminal 3 of the

chime connector block.

3: Test to make sure that the chime is operating correctly.

NB:The chime connector block can be adhered to the chime by

removing the sticky tab cover from the bottom of the connector block.

Transformer Operation: Four Wire Installation

Commonly used in new installations:

1: Connect one of the wires from the Bell Push to terminal 3 of the chime connector

block and the second wire to terminal 4 of the chime connector block.

1: Connect one of the wires from the Transformer to terminal 2 of the

chime connector blockand the second wire to terminal 4 of the chime

connector block.

3: Test to make sure that the chime is operating correctly.

NB: The chime connector block can be adhered to the chime by

removing the sticky tab cover from the bottom of the connector block.

Battery Layout

Wire to Bell Push &

Transformer

Battery Operation:

1: insert 4 x Size ‘C’ (LR14) batteries, take care to make sure that the battery

polarity matches the internal markings.

2: Connect one of the wires from the bell push to terminal 1 of the chimes

connector block.

3: Connect the second wire from the bell push to terminal 4 of the

chimes connector block.

4: Test to make sure that the chime is operating correctly.

NB: The chime connector block can be adhered to the chime by

removing the sticky tab cover from the bottom of the connector

block.

Wire to Bell

Push

Wire to

Bell Push

Wire to

Transformer

:V2

Byron 62570 Owner's manual

Byron 62570 Owner's manual

Byron 62570 Owner's manual

Related papers

Other documents