10
NS-A1113 DVD Executive Shelf System
www.insignia-products.com
Using your DVD Executive Shelf System
Basic operation
Preparing
Before turning on the system, make sure that all of the connections
are correct and secure.
1 Plug the power plugs into the power outlet, then press the Power
button on the front panel to turn on the system. At this time, the
system is in Standby mode, the Red Indicator light on the front
panel is on, and the display shows the current time.
2 Press the Power, FM/AM, Play/Enter, Audio-in, or Eject buttons
on the remote control or the Play/Enter, Stop AM/FM, or Eject
buttons on the front panel to exit Standby mode. The player enters
the mode corresponding to the button you pressed.
3 After exiting Standby mode, press the Eject button on the remote
control or front panel to open the disc tray, insert a disc, then press
the Eject button again. The system starts to play.
Status display
While a disc is playing, press the OSD button and the TV screen
displays the following:
• VCD disc display: Single Elapsed, Single Remain, Total
Elapsed, Total Remain, Off
• DVD disc display: Title Elapsed, Title Remain, Chapter
Elapsed, Chapter Remain, Off
Soundtrack switch
While playing VCDs or DVCDs, press the L/R(MO/ST) button to
select one of the Output modes, such as Mono Left, Mono Right,
Mix-Mono, and Stereo. Press the button once to switch one
soundtrack.
Fast forward and Fast backward
While in Play mode, press the Tune-<< or Tune+>> buttons to fast
forward or fast backward. The available speeds are: FORWARD X2,
FORWARD X4, FORWARD X8, FORWARD X16, PLAY BACKWARD
X2, BACKWARD X4, BACKWARD X8, BACKWARD X16, and PLAY.
Previous and Next
While in Play mode, press the CH- |<< button to skip to the previous
song or press the CH+ |>> button to skip to the next song.
Note
Standby mode is a power-saving mode. However, when you are not
going to use the system for a long time, turn off the main power.
Note
While playing DVDs or SVCDs, this button doesn’t work.