Ingenico AXIUM EX4000 User guide

AXIUM EX4000

User Guide

www.ingenico.com

13-17 rue Pagès, 92150 Suresnes – France

Banks and Acquirers International Holding, SAS / 814 767 216 RCS Nanterre

Contents

Table of Contents

1. Introduction

2. Presentation

2.1 Content of the box

2.2 Overview of AXIUM EX4000

2.3 Key Locations and Functions

2.4 Touch Panel

3. Use of the terminal

3.1 Power on/Power off the terminal

3.2 Reading cards

3.3 Usage of rear camera

3.4 USB Type-C

4. Installation

4.1 Recommendations

4.2 Screen Protective film

4.3 Installing modules

4.4 Battery

4.5 Visual Impaired (VI) Accessory

5. Recommendations

5.1 Safety

5.2 Security of your terminal

5.3 Fixed installation

5.4 Cleaning the terminal

5.5 Transport and storage

6. Standards

7. Troubleshooting

2

3

4

5

7

8

9

10

11

12

15

16

17

19

20

21

26

2

AXIUM EX4000

07/11

Banks and Acquirers International Holding SAS

We hope that you will be fully satisfied with your new AXIUM EX4000

terminal.

Read this guide to understand and make the best use of your terminal. It

presents you the necessary information about use, installation,

maintenance, safety and security recommendations.

1. Introduction

WARRANTY/

SECURITY

This symbol indicates an important Warning.

This symbol indicates a piece of advice.

Use only the power supply included with the product to

ensure best performance and safety. Maintenance should

only be provided by Ingenico authorized technician.

Failure to comply with these instructions will void the

manufacturer’s responsibility.

3

AXIUM EX4000

07/11

Banks and Acquirers International Holding SAS

2. Presentation

2.1 Contents of the box

AXIUM EX4000 terminal

Power adapter

This user guide

Ejector

WARNING

The power supply unit provided with your equipment is

specially designed for INGENICO AXIUM EX4000 terminal.

Do not use any other power supply. The use of a power

supply with apparently similar voltage/current characteristics

may damage your terminal.

ADVICE

Keep the package. It must be re-used whenever the

terminal is shipped.

4

AXIUM EX4000

07/11

Banks and Acquirers International Holding SAS

1) Camera

3) Power key

5) SAM /SIM 2 card slot

7) SIM 1 card slot

9) Speaker

11) Contactless landing zone

2) Volume Keys

4) Micro SD slot

6) Eject hole for SIM/SAM card tray

8) LEDs for Contactless Card

10) Flash

2.2 Overview of AXIUM EX4000

5

AXIUM EX4000

07/11

Banks and Acquirers International Holding SAS

Weight

Dimension (L x W x H)

Electrical mains network

182g

146.8 X 75 X 13.1mm / 5.8 x 2.95 x 0.52 in

100-240VAC/50-60Hz Class II

6

AXIUM EX4000

07/11

Banks and Acquirers International Holding SAS

12) LCD and touch screen

14) Microphone

13) USB Type-C connector

15) Smart card reader

2.3 Key Locations and Functions

Three physical keys on the right side of the terminal: a power button key

and two volume keys.

Three virtual keys at the bottom of the 5-inch screen: Menu, Home and

Back keys.

The AXIUM EX4000 is equipped with touch panel that allows input via finger

or with the use of a stylus.

2.4 Touch Panel

7

AXIUM EX4000

07/11

Banks and Acquirers International Holding SAS

Volume Keys

Power button

Home

Menu Back

3. Use of the terminal

3.1 Power on/Power off the terminal

Press <Power> button for about 1s until the display is turned on.

Press and hold <Power> button for more than 2s until the display shows

the following menu.

Press <Power off>.

If the battery is empty, the terminal will automatically shut off.

In the event of abnormal behavior of the terminal, press and hold the

power button for 8 seconds to force the terminal to reboot.

Terminal reboot:

Power On Terminal:

Power Off Terminal:

Battery Low:

8

AXIUM EX4000

07/11

Banks and Acquirers International Holding SAS

To conserve battery power, the screen may be turned off with a short

press of the power button. (Approximately 0.5 seconds).

Screen saver mode:

3.2 Reading cards

Insert the EMV card

horizontally with the metal

chip facing upward.

Leave card in this position until

the transaction is completed

or prompted to remove it.

Bring the card firmly up to the

active zone.

Keep the card close to the

reader during the transaction.

Do not remove the card until

prompted by application or the

LEDs indicate that the

transaction has been

completed.

Magnetic stripe card

Contactless card

9

AXIUM EX4000

07/11

Banks and Acquirers International Holding SAS

3.3 Usage of rear camera

Rear camera aims at the barcode and moves EX4000 from far to near.

A beep will sound when the barcode is successfully scanned.

3.4 USB Type-C

USB Type-C connector is located on the left

side of the terminal.

The connector manages Host and Slave

connections.

Connector is used for the audio Jack solution.

To prevent possible hearing damage, do not listen at high

volume levels for long periods.

WARRANTY

10

AXIUM EX4000

07/11

Banks and Acquirers International Holding SAS

4. Installation

4.1 Recommendations

(*)Excluding battery charging

Operating conditions

Battery charging conditions

Storage conditions

Ambient temperature*

Ambient temperature

From -10°C to +50°C (14°F to 122°F)

From 0°C to +40°C (32°F to 104°F)

From -20°C to +70°C (-4°F to 158°F)

From 5% to 90%, Non-condensing

Max relative humidity

From 10% to 90%, Non-condensing

Please remove the protective film

from the display before usage.

4.2 Screen Protective film

11

AXIUM EX4000

07/11

Banks and Acquirers International Holding SAS

4.3 Installing modules

4.3.1 SIM1 and SAM / SIM2

The SIM / SAM connectors are located on the right side of the terminal.

Insert the ejector into the hole on the SIM card tray and push hard until

the tray pops out.

ADVICE

SIM and SAM cards share the same form factor , please

ensure that the cards are inserted into the correct slot for

the type of card.

WARNING

Power off the terminal before opening the SIM card tray.

Pull out the SIM card tray and put the SIM or SAM card into the

corresponding position in the tray.

SIM1 and SAM / SIM2 are identified by the engraved marks in the tray.

12

AXIUM EX4000

07/11

Banks and Acquirers International Holding SAS

ADVICE

SAM card and SIM2 share a card slot, one terminal can only

support SAM or SIM2 card, please select the correct card

according to the terminal function and put it into the card

slot.

When put a SIM / SAM into slot, be sure to put the cut corner as

indicated on the picture.

Insert the SIM card tray into the terminal.

SIM1

13

AXIUM EX4000

07/11

Banks and Acquirers International Holding SAS

WARNING

Power off the terminal before opening the SIM card tray.

4.3.2 MicroSD Memory Card

MicroSD connector is located on the right side of the terminal.

Insert the ejector into the hole on the SIM card

tray and push hard until the tray pops out.

Pull out the SIM card tray.

If you want to install the MicroSD card, please

insert the MicroSD card according to the

illustration.

If you want to pull out the MicroSD card, please

press the end of MicroSD card until the

MicroSD card is popping out, then pull out the

MicroSD card.

Insert the SIM card tray into the terminal.

NOTE: The terminal supports SDHC MicroSD

cards up to 32GB.

14

AXIUM EX4000

07/11

Banks and Acquirers International Holding SAS

4.4 Battery

4.4.1 Charging the battery

When does the battery need to be charged?

For safety reasons, the battery included with the terminal is not

fully charged. Please charge the battery before use.

When used daily, the terminal charges its battery each time the

power adapter is connected. Charging starts automatically.

In order to charge the battery:

Using the power adapter

Connect the power adapter to the terminal USB type-C connector

located on the left side of the terminal.

Connect the power adapter to the power supply mains network.

15

AXIUM EX4000

07/11

Banks and Acquirers International Holding SAS

4.5 Visual Impaired (VI) Accessory

slide the accessory onto the

terminal from the bottom.

Install

slide the accessory down and

away from the terminal

Remove

5 Recommendations

5.1 Safety

On airplanes

Explosion areas

Thunderstorm weather

Electronic health appliances

Your terminal must be powered off.

Non-compliance with these safety rules may result in legal action

and/or a ban on later access to cellular network services.

Some regulations restrict the use of radio equipment in chemical plants,

fuel depots and any site where blasting is carried out.

Operation near Fuel Pumps the terminal be protected by a specially

fitted and certified cover enabling use in proximity to a fuel pump.

According to some relevant reports, the mobile phone electromagnetic

wave is good conductor of lightning.

It is much easier to suffer lightning strike when the damp atmosphere

form a magnetic conductivity, especially in open areas.

Do not use wireless terminals under thunderstorm weather.

The terminal is a radio transmitter which may interfere with health

appliances, such as hearing aids, pacemaker, hospital equipment, etc.

Your doctor or the equipment manufacturer will be able to provide you

with appropriate advice.

16

AXIUM EX4000

07/11

Banks and Acquirers International Holding SAS

5.2 Security of your terminal

This device conforms to currently applicable PCI PTS security

requirements.

Upon receipt of the terminal , it is recommended to check for signs of

tampering or other unauthorized modifications to the terminal. It is

recommended to check the following periodically:

The keypad is firmly in place.

There is no evidence of unusual wires that have been connected to any

ports on your terminal or associated equipment.

Device does not display any notifications of being in a “tampered

state”.

In this state the terminal will repeatedly flash the message

“Warning Detected” and further use of the terminal will not be

possible.

If you observe the “Warning Detected” message, you should

contact the terminal helpdesk immediately.

You are strongly advised to ensure that privileged access to your terminal

is only granted to staff that have been independently verified as being

trustworthy. The terminal must never be put in or left at a location where it

could be stolen or replaced by another device.

For situations where it is not possible for the user to pick up the device and

shield their PIN entry . it should be installed in the following manner

5.3 Fixed installation

Angled at 45 or more, so that oversight of the PIN entry from the rear

of the device is not possible.

Fitted in a swivel stand or fixed in the best possible position to prevent

oversight of pin entry during use.

There should be placement of conspicuous notices and educational

material that informs the user to shield their PIN during PIN entry.

17

AXIUM EX4000

07/11

Banks and Acquirers International Holding SAS

The device must be installed so that oversight from other customers is

prevented. This may be achieved through the placement of the lanes

and device, so that the customer is automatically positioned between

the device keypad and other customers. Alternatively, it may be

achieved by the environment in which the device is installed, so that

the checkout itself shields the PIN entry process.

The terminal is recommended for indoor use only within the

aforementioned environmental ranges in Section 4 of this document.

ADVICE

Positioning of the terminal on check stand must be in such a way

to make cardholder PIN (Personal Identification Number) spying

infeasible.

Installing device on an adjustable stand must be in such a way

that consumers can swivel the terminal sideways and/or tilt it

forwards/backwards to a position that makes visual observation

of the PIN-entry process difficult.

Positioning of in-store security cameras such that the PIN- entry

keypad is not visible.

NEVER ask the customer to divulge their PIN Code. Customers

should be advised to ensure that they are not being overlooked

when entering their PIN Code.

18

AXIUM EX4000

07/11

Banks and Acquirers International Holding SAS

5.4 Cleaning the terminal

Unplug all wires from the terminal prior to cleaning.

Apply soapy water or other approved cleaning product to a soft,

non-abrasive cloth.

Good rules for proper cleaning of the terminal are:

CLEANING PRODUCT SHOULD BE APPLIED TO THE CLEANING

CLOTH AND NOT DIRECTLY APPLIED OR SPRAYED TO THE

TERMINAL. Failure to follow this step may result in damage to the

terminal.

Do not clean the electrical connections.

Do not use solvents, detergents or abrasive products: Those

materials might damage the plastic or electrical contacts.

Avoid prolonged exposure of the terminal to the direct rays of the sun.

Do not put anything other than credit cards into the slot of the smart

card reader.

19

AXIUM EX4000

07/11

Banks and Acquirers International Holding SAS

5.5 Transport and storage

When transporting the terminal

Protect the terminal from snow, rain, and excessive exposure to the

sun.

Transport with care to avoid mechanical impact.

Do not throw the unit forcibly. Prevent the package from intrusion

during transportation to avoid breakage. The product should be stored

in the original packaging.

Do not store in warehouses that also contain harmful gases, or

inflammable, explosive, or corrosive chemicals.

Do not expose to strong mechanical vibrations or strong magnetic

fields.

Packaging should be stored at least 15 cm above the ground and be

kept away from heat, cold, windows, or air inlet sources by at least

50cm.

Follow the specific stored conditions as noted in Section 4 of this

document.

20

AXIUM EX4000

07/11

Banks and Acquirers International Holding SAS

Ingenico AXIUM EX4000 User guide

Related papers

Other documents