2. Atoll Electronique
  3. DA100
DA100

Atoll Electronique DA100 Operating instructions

  • Hello! I've reviewed the installation guide for the Atoll Electronique DA100 digital board. This document provides instructions on how to install the board, which features 2 coaxial and 2 optical digital inputs supporting up to 192kHz. I'm ready to answer your questions about the installation process or the board's capabilities.
  • What is the first step before starting installation?
    What is included in the DA100 digital board?
    What models are compatible with this digital board?
DIGITAL BOARD INSTALLATION DA100
Before any operation, switch off your appliance.
Reminder: The DA100 digital board includes:
1) Unscrew the rear plate (3 screws).
2) Place the plastic cover for the
Bluetooth antenna and the USB input.
This board is compatible with IN200 Sig from
serial number 617659, and PR300 Sig from
serial number 626210 then use the cover
below for the USB input:
Engage the board and screw the
board to the chassis.
In case of IN50, 80, 100 and PR200 Signature it is necessary to wait 5 seconds of
initialization before being able to exit standby at the first power on.
https://www.atoll-electronique.com/en/presse-support-2/
Download your owner manual here:
S/PDIF BOARD INSTALLATION
FOR IN & PR SIGNATURE
• 2 Coaxial inputs (24 bits/192 kHz).
• 2 Optical inputs (24 bits/192 kHz).
CHC3x6 screw CHC3x6 screw
2 sheet metal screws
3) Plug the flat cable in the main
board connector.
/