Clarsen K800i Brush On Mould Remover Operating instructions

BRUSH ON GEL

MOULD REMOVER

A powerful, formulation that kills mould and mildew, and removes staining.

For use in areas where there is a heavy and ingrained, mould build-up.

Designed to allow for a longer dwell time, and greater penetration. Provides

long lasting protection against re-growth. Safe to use on most surfaces.

DIRECTIONS FOR USE

1. Spread directly onto the surface, using a brush.

2. Leave to dwell for a few minutes. 3. Rinse away using a damp cloth.

IMPORTANT Causes eye and skin irritation. Contact with eyes and skin should

be avoided. IF ON SKIN: Wash with plenty of soap and water. IF IN EYES: Rinse

thoroughly with water. If medical advice is needed, have product container or

label at hand. Do not use for medical or hygiene purposes. Do not mix with any

other preparations.DO NOT INGEST. If product is ingested, then seek medical

advice. Always test on an inconspicuous area prior to use and only proceed

when satisfied with the results. Rinse hands after use. KEEP OUT OF REACH OF

CHILDREN AND ANIMALS. Read Label before use.

<5% Chlorine based bleaching agents <5% Anionic surfactants

Long-lasting protection

For heavy ingrained mould build-up

250ml

WARNING

Prevents

re-growth

Use inside

and outside

Quick

drying

scrubbing

required

Leaves a

streak-free finish

Download PDF