3 Legged thing R5 Operating instructions

Brand: 3 Legged thing

Model: R5

Type: Operating instructions

For Canon R5 & R6

Instructions

®

BUILT TO ENABLE. CREATED TO INSPIRE

ROXIE

Look at your box.

See that little sticker

with a serial number

and a barcode? Peel

it off and put it here

for safe keeping.

Or don’t.

IMPORTANT

DO NOT USE YOUR L-BRACKET

UNTIL YOU HAVE READ

THESE INSTRUCTIONS. NO

WARRANTY CLAIM WILL BE

ENTERED INTO FOR THE MISUSE

OR INCORRECT USE OF THESE

PRODUCTS.

How to set up your ROXIE L-Bracket for use

1 - Locator Pin

2 - ¼”-20 stainless steel mounting

screw

3 - Door cut-out

4 - Strap connector

5 – 1/4” Accessory threads

6 - Top section of upright

7 - Shorter section of upright

To t ROXIE to your R5 or R6 body, loosen the locator pin (1) screw and place bracket into

the locator slot and tighten. Then tighten the mounting screw (2) to the camera.

1

2

Anatomy of ROXIE:

How to clamp the vertical upright

Make sure when you are clamping the bracket into the portrait position you either clamp the

shorter section (1) of the upright or have both sections (1 & 2) either side of the gap clamped

depending on your clamp length. DO NOT clamp only the top section (3) of the bracket into the

clamp.

11

2

3

®

Unit 9 Kinsbourne Farm

Bury End

Stagsden

Bedfordshire

MK43 8TS

United Kingdom of

Fadeless Splendour

3LT Social Media

#3LeggedThing

/3LeggedThing

@3LeggedThing

1
2
3
4
5

3 Legged thing R5 Operating instructions

Brand: 3 Legged thing

Model: R5

Type: Operating instructions

Download PDF

Other documents