2. 3 Legged thing
  3. R5
R5

3 Legged thing R5 Operating instructions

  • Hello! I've reviewed the instructions for the 3 Legged Thing ROXIE L-Bracket designed for Canon R5 and R6 cameras. This document provides guidance on setup, including how to attach the L-bracket, how to clamp it in different positions, and important warnings about correct usage. I am ready to answer your questions about this product and its features.
  • What should I do before using the L-bracket?
    How to install the ROXIE L-Bracket?
    How to clamp the vertical upright in portrait position?
For Canon R5 & R6
Instructions
®
BUILT TO ENABLE. CREATED TO INSPIRE
ROXIE
Look at your box.
See that little sticker
with a serial number
and a barcode? Peel
it off and put it here
for safe keeping.
Or don’t.
IMPORTANT
DO NOT USE YOUR L-BRACKET
UNTIL YOU HAVE READ
THESE INSTRUCTIONS. NO
WARRANTY CLAIM WILL BE
ENTERED INTO FOR THE MISUSE
OR INCORRECT USE OF THESE
PRODUCTS.
How to set up your ROXIE L-Bracket for use
1 - Locator Pin
2 - ¼”-20 stainless steel mounting
screw
3 - Door cut-out
4 - Strap connector
5 – 1/4” Accessory threads
6 - Top section of upright
7 - Shorter section of upright
To t ROXIE to your R5 or R6 body, loosen the locator pin (1) screw and place bracket into
the locator slot and tighten. Then tighten the mounting screw (2) to the camera.
1
2
Anatomy of ROXIE:
How to clamp the vertical upright
Make sure when you are clamping the bracket into the portrait position you either clamp the
shorter section (1) of the upright or have both sections (1 & 2) either side of the gap clamped
depending on your clamp length. DO NOT clamp only the top section (3) of the bracket into the
clamp.
11
2
3
®
Unit 9 Kinsbourne Farm
Bury End
Stagsden
Bedfordshire
MK43 8TS
United Kingdom of
Fadeless Splendour
3LT Social Media
#3LeggedThing
/3LeggedThing
@3LeggedThing
/