12-Volt Inflator
Operating Instructions
Model: AF010400
IN642700AV 2/17
© 2017 Campbell Hausfeld
A Marmon/Berkshire Hathaway Company
EN
REGISTER YOUR PRODUCT ONLINE NOW! www.campbellhausfeld.com
READ AND FOLLOW ALL INSTRUCTIONS
SAVE THESE INSTRUCTIONS • DO NOT DISCARD
Please read and save these instructions. Read carefully before
attempting to assemble, install, operate or maintain the product
described.
Protect yourself and others by observing all safety information. Failure
to comply with instructions could result in personal injury and/or
property damage! Retain instructions for future reference.
REMINDER: Keep your dated proof of purchase for warranty purposes!
Attach it to this manual or file it for safekeeping.
Please see page 6 for Safety Glossary and Safety Symbols.
Model #: ________________________________
Purchase Date: __________________________
For parts, product & service information
visit www.campbellhausfeld.com
Campbell Hausfeld
100 Production Drive
Harrison, Ohio 45030
BEFORE YOU BEGIN
Description
This 12-volt inflator comes with an inflation nozzle, sports needles, and
PRESTA valve adaptor. The inflator can be used for emergency roadside tire
inflation and to inflate bike tires, soccer balls, beach balls and other sporting
equipment.
UNPACKING
After unpacking the unit, inspect carefully for any damage that may have
occurred during transit. Check for loose, missing or damaged parts. Check
to be sure all supplied accessories are enclosed with the unit. In case of
questions, damaged or missing parts, please visit www.campbellhausfeld.com
for customer assistance.
Do not operate unit if damaged during shipping,
handling or use. Damage may result in bursting and
cause injury or property damage.
Other Parts (Not Provided)
You will need the following to operate this Campbell Hausfeld inflator:
• 12-volt DC power outlet rated 15 amps or higher
• Separate tire gauge to confirm pressure in tires.
SPECIFICATIONS
AF010400
Maximum Pressure 150 PSI
Voltage 12V, DC
Fuse 15A
Cord Length 10 ft.
Hose Length 31 in.
Flashlight LED
Gauge Analog
Air Outlet Shrader Valve
Flow Rate @ 0 PSI 0.9 CFM
Flow Rate @ 35 PSI 0.6 CFM
Inflation Speed * 4 minutes
Weight 4.2 lbs.
Includes: (2) sports needles, inflation nozzle, and PRESTA valve adaptor.
* Inflation speed is the average time measured to inflate a 195/65/R15 tire from 0 psi to
35 psi
1
2
DIMENSIONS
Length 8 in.
Width 3.5 in.
Height 6.25 in.
GETTING TO KNOW YOUR UNIT
Figure 1
LED Flashlight
Analog Gauge
PRESTA Valve
ON / OFF Switch
Inflation Nozzle
Inflation
Hose
12V Power Cord
Air Hose
Connector
Sports Needle
3
OPERATION
Tires
1. Before inflating the tire, review
all warnings listed in the GENERAL
SAFETY INSTRUCTIONS section of this
operating manual.
2. Remove valve stem cap.
3. Turn the air hose connector onto the
valve stem in a clockwise direction
until snug (See Figure 2).
4. Plug power cord into 12-volt DC
power outlet.
For use with 12-volt DC power outlets rated 15 amps
or higher. Do not use with older 8 amp cigarette
lighter receptacles or fuse will blow and inflator will not work.
5. Turn power switch on.
6. Stop inflation when the proper pressure has been reached.
Recommended tire inflation pressure for the vehicle can typically be
found in the vehicle’s owner’s manual or on the driver’s side door jamb.
7. Do not over inflate tires as tires may rupture/explode causing serious
injury and/or property damage.
8. Tire inflation should only be done in a safe area, well off roadway and
away from traffic. Use reflective warning triangles and/or safety flares
to alert other drivers of roadside emergency. Always follow the tire
inflation safety advice and procedures noted in the vehicle’s operating
manual.
Inflatables
1. To use the inflation accessories, screw appropriate inflation accessory
into the air hose connector until snug.
2. Insert the inflation accessory into the inflatable object (tire, football raft,
etc.) and turn on the inflator.
3. When the object is firm, switch the inflator off. Do not over inflate
objects as objects may rupture/explode causing serious injury and/or
property damage.
Fuse Replacement
Never replace a blown fuse with a fuse having a
higher rating. Using a higher rated fuse will transmit
too much current to the inflator’s wiring causing it to overheat, melt or,
possibly, catch fire.
1. Unscrew end of plug counter-clockwise to remove fuse.
2. If fuse is blown, replace with a new 15-amp fuse. Always replace a blown
fuse with the same size fuse.
3. Reassemble plug. Do not over-tighten.
Figure 2
4
TECHNICAL SERVICE
For information regarding the operation or repair of this product, please visit
www.campbellhausfeld.com
GENERAL SAFETY INSTRUCTIONS
This manual contains information that is very important to know and
understand. This information is provided for SAFETY and to PREVENT
EQUIPMENT PROBLEMS. To help recognize this information, observe the
symbols found on page 6. The Safety Symbols throughout this manual are to
alert you to important safety hazards and precautions.
The DANGER, WARNING, CAUTION, and NOTICE notifications
and instructions in this manual cannot cover all possible condi-
tions and situations that may occur. It must be understood by
the operator that caution is a factor which cannot be built into
this product, but must be supplied by the operator.
With any piece of equipment, new or used, the most important part of its
operation is SAFETY!
Campbell Hausfeld encourages you to familiarize yourself with your new
equipment and stresses safe operation.
The next few pages of this manual are a summary of the main safety aspects
associated with this unit. Be sure to read and understand completely before
operating the machine.
The symbols used throughout the operation and maintenance sections of
this manual call attention to safety procedures.
California Proposition 65
• This product or its power cord may contain chemicals known to the State
of California to cause cancer and birth defects or other reproductive
harm. Wash hands after handling.
Important Safety Information
Please read and save these instructions. Read carefully before attempting to
assemble, install, operate or maintain the product described. Protect yourself
and others by observing all safety information. Failure to comply with
instructions could result in personal injury and/or property damage! Retain
instructions for future reference.
This manual contains important safety, operational and maintenance
information. If you have any questions, please visit
www.campbellhausfeld.com for customer assistance.
MANUAL
5
General Safety
• Always operate this tire inflator in an open and well-ventilated area and
not inside a confined area, such as a garage. Doing so may lead to bodily
harm or asphyxiation resulting in death.
• Do not leave the inflator unattended while the unit is running.
• Wear eye protection during the inflation process. Never exceed the
recommended pressure for any inflatable object. Do not over inflate
objects as objects may rupture/explode causing serious injury and/or
property damage.
• The air hose connector must be properly connected to secure the
inflation accessories. Use extreme caution when using inflation
accessories.
• Always put the car in park; set the emergency brake; and “chock” the
wheels before using the inflator as personal injury and/or property
damage may occur.
• Tire inflation should only be done safely away from the roadway, with
use of triangles or flares, and in compliance with the vehicle’s operating
manual.
• Always use a separate pressure gauge to check the actual pressure in
tires and in low pressure inflatable objects.
• Inflator must cool for 20 minutes after 20 minutes of continuous
operation. The inflator is not designed to operate continuously for more
than 20 minutes. Exceeding recommended run-time or not allowing for
adequate cooling will cause inflator to overheat and could damage or
destroy inflator.
• When using inflator on high pressure tires, such as those used on large
trucks, trailers or tractors, tire inflation must be executed in stages--NOT
exceeding the 20 minutes of run-time and NOT omitting the 20 minutes
of cooling required for proper use of this inflator.
• Make sure the air hose connector is properly connected to the valve
stem. Failure to properly connect the air hose will result in slower
inflation and/or no air getting to the tire.
• Inflator will get hot to the touch and may cause serious injury--do not
hold or touch while operating. Keep away from flammable materials.
GENERAL SAFETY INSTRUCTIONS (CONTINUED)
Safety Glossary
This manual contains information that is very important to know and
understand. This information is provided for SAFETY and to PREVENT
EQUIPMENT PROBLEMS. To help recognize this information, observe the
following symbols.
Danger indicates an imminently hazardous situation
which, if not avoided, WILL result in death or serious
injury.
Warning indicates a potentially hazardous situation
which, if not avoided, COULD result in death or
serious injury.
Caution indicates a potentially hazardous situation
which, if not avoided, MAY result in minor or
moderate injury.
Notice indicates important information, that if not
followed, may cause damage to equipment.
IMPORTANT or NOTE: Information that requires special attention.
Safety Symbols
The following Safety Symbols appear throughout this manual to alert you to
important safety hazards and precautions.
SAVE THESE INSTRUCTIONS
DO NOT DISCARD
6
Risk of
Pressure
MANUAL
Read Manual
First
7
TROUBLESHOOTING GUIDE
SYMPTOM CORRECTIVE ACTION
Inflator does not turn on or
blows fuses
1. Push the power plug firmly into the receptacle and twist it
back and forth.
2. Check receptacle and plug terminal for dirt. Use a non-
conductive probe--not fingers or anything metal—to check
and clean receptacle and/or terminal.
3. Check vehicle power outlet fuse; should be a minimum of 15
amps.
4. Check inflator fuse, located
in the plug adaptor. To
access fuse, unscrew the
tip of the plug adaptor,
remove old fuse and
inspect. Replace fuse, if
needed.
Inflator runs but tire/article does
not inflate
1. Ensure air hose connector is properly seated on the valve stem
and tightened.
2a. Check tire/article for leaks. Check inflator hose for cracks and
leaks at fittings.
2b. Inspect tire/article to confirm there are no punctures or
sidewall tire damage.
3. If the tire is completely flat, it is possible that the tire has
separated from the rim. If so, the tire inflator will not deliver
the volume of air needed to inflate tire.
Inflator runs slowly 1. Inflator is overheated from too much use. Shut inflator off and
allow to cool for 20 minutes.
2. Voltage powering the 12V outlet is too low. Check the
condition of (car) battery.
Reminder: Keep your dated proof of purchase for warranty purposes! Attach it to this manual or file it
for safekeeping.
LIMITED WARRANTY
1. DURATION: From the date of purchase by the original purchaser as follows: One (1) Year.
2. WHO GIVES THIS WARRANTY (WARRANTOR): Campbell Hausfeld a Marmon/Berkshire Hathaway
Company, 100 Production Drive, Harrison, Ohio, 45030. Visit www.campbellhausfeld.com
3. WHO RECEIVES THIS WARRANTY (PURCHASER): The original purchaser (other than for purposes of
resale) of the Campbell Hausfeld product.
4. WHAT PRODUCTS ARE COVERED BY THIS WARRANTY: Any Campbell Hausfeld nailer, stapler, air tool,
spray gun, inflator or air accessory supplied or manufactured by Warrantor.
5. WHAT IS COVERED UNDER THIS WARRANTY: Substantial defects in material and workmanship which
occur within the duration of the warranty period.
6. WHAT IS NOT COVERED UNDER THIS WARRANTY:
A. Implied warranties, including those of merchantability and FITNESS FOR A PARTICULAR
PURPOSE ARE LIMITED FROM THE DATE OF ORIGINAL PURCHASE AS STATED IN THE DURATION.
If this product is used for commercial, industrial or rental purposes, the warranty will apply for
ninety (90) days from the date of purchase. Some States do not allow limitation on how long an
implied warranty lasts, so the above limitations may not apply to you.
B. ANY INCIDENTAL, INDIRECT, OR CONSEQUENTIAL LOSS, DAMAGE, OR EXPENSE THAT MAY
RESULT FROM ANY DEFECT, FAILURE, OR MALFUNCTION OF THE CAMPBELL HAUSFELD
PRODUCT. Some States do not allow the exclusion or limitation of incidental or consequential
damages, so the above limitation or exclusion may not apply to you.
C. Any failure that results from an accident, purchaser’s abuse, neglect or failure to operate
products in accordance with instructions provided in the owner’s manual(s) supplied with
product. Accident, purchaser’s abuse, neglect or failure to operate products in accordance with
instructions shall also include the removal or alteration of any safety devices. If such safety
devices are removed or altered, this warranty is void.
D. Normal adjustments which are explained in the owner’s manual(s) provided with the product.
E. Items or service that are normally required to maintain the product, i.e. o-rings, springs,
bumpers, debris shields, driver blades, fuses, batteries, gaskets, packings or seals, fluid nozzles,
needles, sandblast nozzles, lubricants, material hoses, filter elements, motor vanes, abrasives,
blades, cut-off wheels, chisels, chisel retainers, cutters, collets, chucks, rivet jaws, screw driver
bits, sanding pads, back-up pads, impact mechanism, or any other expendable part not
specifically listed. These items will only be covered for ninety (90) days from date of original
purchase. Underlined items are warranted for defects in material and workmanship only.
7. RESPONSIBILITIES OF WARRANTOR UNDER THIS WARRANTY: Repair or replace, at Warrantor’s
option, products or components which are defective, have malfunctioned and/or failed to conform
within duration of the warranty period.
8. RESPONSIBILITIES OF PURCHASER UNDER THIS WARRANTY:
A. Provide dated proof of purchase and maintenance records.
B. Deliver or ship the Campbell Hausfeld product or component to the nearest Campbell Hausfeld
Authorized Service Center. Freight costs, if any, must be borne by the purchaser.
C. Use reasonable care in the operation and maintenance of the products as described in the
owner’s manual(s).
9. WHEN WARRANTOR WILL PERFORM REPAIR OR REPLACEMENT UNDER THIS WARRANTY: Repair
or replacement will be scheduled and serviced according to the normal work flow at the servicing
location, and depending on the availability of replacement parts.
This Limited Warranty applies in the United States, Canada and Mexico only and gives you specific legal
rights. You may also have other rights which vary from state to state or country to country.
8
Pompe de gonflage 12volts
Instructions d’Utilisation
Modèle: AF010400
IN642700AV 2/17
© 2017 Campbell Hausfeld
A Marmon/Berkshire Hathaway Company
FR
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Inflador de 12 voltios
Manual de Instrucciones
Modelo: AF010400
IN642700AV 2/17
© 2017 Campbell Hausfeld
A Marmon/Berkshire Hathaway Company
SP
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
/
