GATCO 1460 Installation guide

Type
Installation guide

This manual is also suitable for

GENERAL INSTALLATION INSTRUCTIONS
Elegant Shower Shelf 1460, 1461, 1467 & 1468
Fig. 1
Fig. 2
Fig. 4
Side View
Tiles
2 Mounting pins
2 Set screws
1 Shelf
2 Mounting Screws 1 Allen Wrench2 Tile Anchors
Mounting Kit
Mark the center
as accurately as possible
Fig. 3
Preparation
Tools Required for Assembly: (Not included)
• Pencil
• Electrical drill
• ¼” Masonry drill bit (for tile anchor)
• Level
CAUTION: Tile anchors are for tile, granite, marble, cement surfaces only.
To maintain the beautiful luster finish, please use soft damp cloths
when cleaning and never use any cleaning solvents.
Care and Maintenance
Installation Instructions
The manufacturer reserves the right to, and do time to time, make changes and improvements in designs and dimensions.
Updated on May 12, 2015
• Safety glasses
1. Hold the shelf up against desired position on wall.
Outline the end of the posts. (Fig.1) Use a level for accuracy.
2. Using the enclosed Allen Wrench, loosen two set screws at the end.
Remove two mounting pins from the posts. (Fig.2)
DO NOT loosen the other set screws.
Position the mounting pins inside the outlines drawn in Step 1.
Mark the holes as accurate as possible into the center. (Fig. 3)
3. Drill pilot holes into the tiles where the tile anchors will be inserted.
Use ¼” Masonry drill bit. Insert tile anchors into the holes.
CAUTION: Accuracy is an essential part of a successful installation.
Make sure the holes are drilled straight as marked.
4. Place the mounting pins over the tile anchors.
Insert the enclosed screws over the mounting pins and tighten. (Fig.4)
5. Place the shelf over the mounting pins.
Use enclosed Allen Wrench to tighten the set screw. (Fig.2)
Items Included in the Package
  • Page 1 1

GATCO 1460 Installation guide

Type
Installation guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI