GATCO 1433 Installation guide

GENERAL INSTALLATION INSTRUCTIONS

Item being installed

Tiles

PREPARATION

Tools Required for Assembly: (Not included)

• Pencil

• Electrical drill

• 1/4” Masonry drill bit (for tile anchor)

• Phillips head screwdriver

• Tape measure

CAUTION: Tile anchors are for tile, granite, marble, cement surfaces only. Use drywall anchors for drywalls only.

1. Unscrew cap to reveal screw holes shown in Fig.1.

2. Hold the item up against desired position on wall, and mark the screw holes.

Use a measuring tape and a level for accuracy.

3. Remove the item and drill pilot holes into the tiles where the tile anchors

will be inserted using 1/4” Masonry drill bit.

4. Insert tile anchors into the hole.

5. Place the item over the tile anchors and place mounting kits in the order

shown in Fig.2. Tighten screw, then tighten cap over the screw.

To maintain the beautiful luster finish, please use soft damp cloths

when cleaning and never use any cleaning solvents.

Care and Maintenance

Tiles

The manufacturer reserves the right to, and do time to time, make changes and improvements in designs and dimensions.

Updated on August 19, 2014

Fig. 1

Fig. 2 Side View

INSTALLATION INSTRUCTIONS

• Level

• Safety glasses

This manual is also suitable for

Download PDF