Audiovox CMOS2 Installation guide

Brand: Audiovox

Model: CMOS2

Type: Installation guide

Audiovox CMOS2

The Audiovox CMOS2 is a versatile 5-in-1 high-resolution rear-view camera kit that can be installed in five different ways to enhance your driving experience:

Bumper Mounted: Drill a hole in the rear bumper and insert the camera for a discreet and secure installation.
Traditional Drilled/Angled Mount: Use the included angle rings and brackets to adjust the camera's angle for optimal visibility.
With Long Butterfly Style Bracket: Mount the camera using the long butterfly bracket for flexible positioning on various surfaces.
With Short Butterfly Style Bracket: Similar to the long bracket, the short bracket provides a secure and adjustable mount for the camera.

Audiovox CMOS2

The Audiovox CMOS2 is a versatile 5-in-1 high-resolution rear-view camera kit that can be installed in five different ways to enhance your driving experience:

Bumper Mounted: Drill a hole in the rear bumper and insert the camera for a discreet and secure installation.
Traditional Drilled/Angled Mount: Use the included angle rings and brackets to adjust the camera's angle for optimal visibility.
With Long Butterfly Style Bracket: Mount the camera using the long butterfly bracket for flexible positioning on various surfaces.
With Short Butterfly Style Bracket: Similar to the long bracket, the short bracket provides a secure and adjustable mount for the camera.

• Cameramainunit

• TrimRing

• Mainring

• Slimanglering

• Anglering

• Lockingring

• Longbutterfly

bracket

• Shortbutterfly

bracket

• Surfacemount

bracket



InstructionManualforCMOS2

5‐in‐1Rear‐viewCamera



DearCustomer,

CONGRATULATIONS!This5‐in‐1highresolutionrear‐view

camerakitwhenusedasdescribedcanbeinstalledin5

differentwaysandwillimproveyourabilitytoseewhat

behindyoucar,CRVormini‐van.Wehavetakennumerous

measuresinqualitycontroltoensurethatyour

products

arriveintopconditionandwillperformtoyoursatisfaction.



BEFOREYOUINSTALL



Automotivevideoequipmentinstallationscanbedifficultat

times,eventothemostexperiencedinstallationtechnicians.

Ifyouarenotconfidentworkingwith12voltDCvehicle

wiring,removingandreinstallinginteriorpanels,carpetingor

othercomponentsofyourvehicle,contactthevehicle’s

manufacturerorconsiderhavingthesysteminstalled

professionally.



PARTS



1. Cameramainbodywith70”powerandsignalcable.



2. Partspackagelistedbelow:



INSTALLATIONINSTRUCTIONS

Thiscamerakitcanbeinthefollowinginstallations:

a. BumperMounted

b. TraditionalDrilled/AngledMount

c. WithLongButterflyStyleBracket

d. WithShortButterflyStyleBracket

e. SurfaceMountedStyle



NOTE:TheTrimRing(Partno#2)canbepaintedinanycolor

andthenreplacedtomatch

theVehicleColor.DONOTPAINT

ONTHECAMERA.

A.BumperMounted

Beforeyoudrillaholeontherearbumper,youmustcheck

whatisbehindwhereyouaredrilling.Ifthereareanyvehicle

components,suchaselectricalpartsorfuelsystem

componentsbehindwhereyouaredrilling,youmusttake

whateverprecautionnecessarynottodamagethem.Insure

you

haveenoughdepthforthecamerahousing.

1. Youwillonlyneed#2attachedtothe

camera.

2. Usea15/16”diameterholesawtodrill

aholeontherearbumper.

3. Insertthecamer acableintothehole

andcarefullyfeedthroughthehole.Routethecableinto

the

trunkorTailLightHousingarea.

4. Connectthecamerapowercable:Redtoreverselamp

power+12Vandblacktoground.

5. Connectthemonitorandcamerausing

avideocoaxcable.

NOTE:DONOTUSEANAUDIORCA

CABLE.



B.TraditionalDrilled/AngledMount

1. Parts#3,4,5,&6maybeuseddependingonthe

mountinglocationselected.Useanycombinationto

adjusttoyourrequiredmountingangle.

2. Usea15/16”diameterholesawtodrillaholeinthe

mountinglocation.

3. Insertthecamer acableinto

theholeand

carefullyfeed

through.

4. Routethecableintothetrunk

ortaillighthousingarea.

5. Connectthecamerapower

cable:Redtoreverselamp

power+12Vandblackto

ground.

6. Connectthemonitorandcamerausingavideocoax

cable.

NOTE:DONOTUSEANAUDIORCACABLE.



C.LongButterflyStyleBracket

1. Parts#2,#1#3,#7,

#4,#5and#6May

befortheButterfly

mountatany

positiononthe

camera.

2. Mountthecamerausingtwoscrews.Alwaysinspectthe

installationlocationtoverifythereisnothinglocated

behindyourmountinglocation.

3. Routethecableintothe

trunkortaillighthousingarea.

4. Connectthecamerapowercable:Redtoreverselamp

power+12Vandblacktoground.

5. Connectthemonitorandcamerausingavideocoax

cable.

NOTE:DONOTUSEANAUDIORCACABLE.



D.ShortButterflyStyleBracket

1. Parts#2,#1,

#3,#4,#5,#8

and#6mayfor

theButterfly

mountatany

positiononthe

camera.

2. Mountthecamerausingtwoscrews.Alwaysinspectthe

installationlocationtoverifythereisnothinglocated

behindyourmountinglocation.

3. Routethecableintothetrunk

or

taillighthousingarea.

4. Connectthecamerapowercable:

Redtoreverselamppower+12V

andblacktoground.

5. Connectthemonitorandcamera

usingavideocoaxcable.

NOTE:DONOTUSEANAUDIORCACABLE.



E.SurfaceMountedPlasticBracket 

1. CombineParts#2,#1,#9,#2and#6.

2. Mountthecamerausingtwoscrews.Alwayslookbefore

youscrewintothevehicletomakesurethereisnothing

locatedbehindyourmountinglocation.

3. RoutethecableintothetrunkorTailLightHousingarea.

4. Connectthe

camerapowercable:Redtoreverselamp

power+12Vandblacktoground.

5. Connectthemonitorandcamerausingavideocoax

cable.

NOTE:DONOTUSEANAUDIORCACABLE.



12MONTHLIMITEDWARRANTY

AppliestoAudiovoxSeriesControlModulesand Sensors.



AUDIOVOXElectronicsCorporation(theCompany)warrants

totheoriginalretailpurchaserofthisproductthatshouldthis

productoranypartthereof,(otherthantransmitters)under

normaluseandconditions,beprovendefectiveinmaterialor

workmanshipwithin12monthsfromthedate

oforiginal

purchase,suchdefect(s)willberepairedorreplacedwith

neworreconditionedproduct,(attheCompany’soption)

withoutchargeforpartsorrepairlabor.

Toobtainrepairorreplacementwithinthetermsofthis

Warranty,theproductistobedeliveredwithproofof

warrantycoverage(e.g.dated

billofsale),specificationof

defect(s),transportationprepaid,toanapprovedwarranty

station.ThisWarrantyisnotassignableortransferable.

ThisWarrantydoesnotcoverdamagetothevehicle’s

electricalsystemorcostsincurredforremovalor

reinstallationoftheproduct.ThisWarrantydoesnotcover

batteriesnorapplytoany

productorpartthereofwhich,in

theopinionoftheCompany,hassufferedorbeendamaged

throughalteration,improperinstallation,mishandling,

misuse,abuse,neglect,accident,orbyremovalor

defacementofthefactoryserialnumber/barcodelabel(s).

ThisWarrantyisinlieuofallotherexpresswarrantiesor

liabilities.ANY

IMPLIEDWARRANTIES,INCLUDINGANY

IMPLIEDWARRANTYOFMERCHANTABILITY,SHALLBE

LIMITEDTOTHEDURATIONOFTHISWRITTENWARRANTY .

ANYACTIONFORBREACHOFANYWARRANTYHEREUNDER

INCLUDINGANYIMPLIEDWARRANTYOFMERCHANTABILITY

MUSTBEBROUGHTWITHINAPERIODOF24MONTHSFROM

THEDATEOFORIGINALPU RCHASE.INNOCASESHALL

THE

COMPANYBELIABLEFORANYCONSEQUENTIALOR

INCIDENTALDAMAGESFORBREACHOFTHISORANYOTHER

WARRANTY .Nopersonorrepresentativeisauthorizedto

assumefortheCompanyanyliabilityotherthanexpressed

hereininconnectionwiththesaleofthisproduct.

Thecompanydoesnotwarrantthatthis

productcannotbe

compromisedorcircumvented.THEEXTENTOFTHE

COMPANY'SLIABILITYUNDERTHISWARRANTYISLIMITEDTO

THEREPAIRORREPLACEMENTPROVIDEDABOVEAND,INNO

EVENT,SHALLTHECOMPANY'SLIABILITYEXCEEDTHE

PURCHASEPRICEPAIDBYPURCHASERFORTHEPRODUCT

WITHOUTCOSTOFINSTALLATION.

Somestatesdonotallow

limitationsonhowlonganimplied

warrantylastsortheexclusionorlimitationofincidentalor

consequentialdamagesotheabovelimitationsorexclusions

maynotapplytoyou.ThisWarrantygivesyouspecificlegal

rightsandyoumayalsohaveotherrightswhichvaryfrom

statetostate.



Audiovox

ElectronicsCorporation

150MarcusBlvd.

Hauppauge,NewYork11788

1‐800‐645‐4994



Audiovox CMOS2 Installation guide

Brand: Audiovox

Model: CMOS2

Type: Installation guide

Audiovox CMOS2

The Audiovox CMOS2 is a versatile 5-in-1 high-resolution rear-view camera kit that can be installed in five different ways to enhance your driving experience:

Bumper Mounted: Drill a hole in the rear bumper and insert the camera for a discreet and secure installation.
Traditional Drilled/Angled Mount: Use the included angle rings and brackets to adjust the camera's angle for optimal visibility.
With Long Butterfly Style Bracket: Mount the camera using the long butterfly bracket for flexible positioning on various surfaces.
With Short Butterfly Style Bracket: Similar to the long bracket, the short bracket provides a secure and adjustable mount for the camera.

Download PDF

report

Audiovox CMOS2 Installation guide

Audiovox CMOS2 Installation guide

Related papers

Other documents