2. Health & beauty
  3. Digital body thermometers
  4. iGear
  5. iG-R5
iG-R5

iGear iG-R5 User manual

  • Hello! I've reviewed the user manual for the iGear Infrared Thermometer iG-R5. This document provides instructions on how to use the non-contact forehead thermometer, including its body and surface temperature measurement modes, fever alerts and backlit display. I am ready to answer your questions about the device.
  • How to turn on the thermometer?
    How to switch between body and surface temperature measurement modes?
    How to switch between Celsius and Fahrenheit?
    What is the normal temperature range?
    What is the fever temperature range?
    What happens if the temperature is too low?
    What happens if the temperature is too high?
Non-Contact
Infrared Thermometer
Model No.: iG-R5
Highest: Exceed the
highest temperature
range:above 43°C
Red backlight turns
on and buzzer rings
5 times
Fever: 38°C ~ 42.9°C
Red backlight turns
on and buzzer rings
5 times
High: 37.5°C ~ 37.9°C
Orange backlight
turns on
Press "Measure" button, the
screen will light up and
display all information. Press
“Measure” button again, to
start measuring temperature.
If no key is pressed for more
than 15 seconds it will turn off
automatically.
Screen Display
Illustration
Lowest: Exceed the
lowest temperature
range below 32°C
Red backlight turn on
Normal: 34°C ~ 37.4°C
Green backlight turns
on and buzzer rings
once
Infrared Thermometer iG-R5
measures the body temperature
based on the infrared energy
emitted from the forehead.
Users can quickly get measure-
ment results after positioning
properly the temperature probe
on the forehead.
I. Remove the battery cover,
insert the batteries in
accordance with the positive
and negative pole indications,
then install the battery cover.
2. Click the measure button once
to power it on, if display shows
‘Body Temp' it means it is ready
to measure body temperature. If
the display does not show 'Body
Temp' it means it is ready to
measure surface temperature.
3. Click the measure button
twice to toggle between body
temperature and surface
temperature.
4. Click the measure button
three times to toggle between
DEG C/F.
5. Please note: Do not press the
measure button while you install
batteries. If display shows any
unknown content, please
reinstall batteries.
Instructions
/