2. Topkodas
  3. PROGATE
PROGATE

Topkodas PROGATE User manual

  • Hello! I've read the user manual for the Topkodas PROGATE GSM controller and understand its functions. This device allows you to control outputs via SMS and free short calls, and you can configure it using SERA2 software. I'm ready to answer any questions you have about the features and setup described in the manual.
  • How can I control the relay output initially?
    How to control relay output with free short call?
    What happens if I call from a different phone number?
    How to configure the controller?
    How can output be activated or deactivated by SMS?
Control using SMS & free short call
•The controller comes factory pre-configured to work. A first call
from any phone to controller’sSIM card number will turn on the
RELAY output for 2 seconds.
NOTE:
•The phone number will be stored in the module’s memory
automatically. It will allow to control RELAY output with free short
call.
•Calls from different phone number will be rejected.
•The controller can be installed without any additional configuration if
such operation mode is acceptable.
•The controller configuration can be changed with free configuration
software SERA2
•Install and open SERA2 software. [ https://www.topkodas.lt/downloads/ ]
•Connect PROGATE to the computer via mini USB cable
•Connect power supply
•Insert SIM card.
•Screw GSM antenna
•Press “Read”
•Go to SERA2>Users/ Access control
•Enter phone number, select OUT1
•Press “Write”
•Go to Sera2> Outputs (PGM)> Mode > Steady or Pulse
•Press “Write”
Control via free short call
1. To control the gate with a free short call or SMS, the phone number needs to be stored in the module memory
In the SERA2> Users/Access control window, and it is not marked under "Guest mode on USER 9.
Then calls from other phone numbers will be ignored
2. If you want the output to be controlled by a free call from any phone number, mark the box next to
"Guest mode on USER 9
Control via SMS
Activate or deactivate selected output
USER123456˽021˽N#ST
•021= command code
(Activate or deactivate selected output N)
•N = output number
•ST= output mode:
0 –deactivated output, 1- activated output
- Identification:
USER –User used for module’s control.
- Installer’s or user’s password.
- space character
- Command code.
- space character
- First configuration array
- space character
- Second configuration array
- etc.
•Go to https://old.topkodas.lt
•Install and open
More information:
•Website: https://www.topkodas.lt/downloads/
•Email: info@topkodas.lt
/