45 EL
45S EL
LADYBIRD
71503804/0
CG rsb STIGA-71503804/0 22-12-2003 11:27 Pagina 1
1
CG rsb STIGA-71503804/0 22-12-2003 11:27 Pagina 1
2
CG rsb STIGA-71503804/0 22-12-2003 11:27 Pagina 2
53
ENGLISH
GB GB
SAFETY REGULATIONS
1) Read the instructions carefully. Get familiar
with the controls and the proper use of the
equipment. Learn how to stop the engine quick-
ly.
2) Only use the lawnmower for the purpose for
which it was designed, i.e. for cutting and col-
lecting grass. Any other use can be hazardous,
causing injury or damage to people and/or
property.
3) Never allow children or people unfamiliar with
these instructions to use the lawnmower. Local
regulations may restrict the age of the operator.
4) Never use the lawnmower:
– When people, especially children, or pets are
nearby;
– If the operator has taken medicine or sub-
stances that can affect his ability to react and
concentrate.
5) Remember that the operator or user is
responsible for accidents or hazards occurring
to other people or their property.
1) While mowing, always wear sturdy footwear
and long trousers. Do not operate the equip-
ment when barefoot or wearing open sandals.
2) Thoroughly inspect the area where the equip-
ment is to be used and remove all objects which
may be thrown by the machine (stones, sticks,
metal wire, bones, etc.)
3) Before use, always inspect the machine,
especially the condition of the blades, and
check that the screws and cutting assembly are
not worn or damaged. Replace worn or dam-
aged blades and screws in sets to preserve bal-
ance.
4) Before mowing, attach the discharge opening
guards (grass-catcher or stone-guard).
5) WARNING: DANGER! Damp and electricity do
not go together:
– cables must be handled and wired when dry
– never allow contact between an electric
socket or cable with a wet area (puddles or
damp grass);
– connections between cables and sockets
must be of the waterproof type. Only use exten-
sion cables with moulded-on waterproof or
approved sockets available commercially.
– power the machine using a residual current
device (RCD Residual Current Device) with max.
30 mA tripping current.
6) The power supply cables must not be of
lower quality than the H05RN-F or H05VV-F type
with minimum cross-section size of 1.5 mm
2
and max. 25 m long.
7) Attach the cable onto the cable clamp before
B) PREPARATION
A) TRAINING
starting the machine.
8) The permanent wiring of any electrical device
to the mains must be carried out by a qualified
electrician, in accordance with electrical regu-
lations in force. Incorrect wiring may cause
severe injury or death.
1) Mow only in daylight or good artificial light.
2) Avoid operating the equipment on wet grass
or in the rain.
3) Never go over the electric cable with the
lawnmower. While cutting, the cable should
always be pulled behind the lawnmower and
always from the area of grass already cut. Use
the cable clamp as described in this manual to
prevent the cable from disconnecting by acci-
dent. Ensure that it is properly inserted without
forcing into the power socket.
4) Never pull the lawnmower by its power cable
or pull the cable to remove the plug. Do not
expose the cable to sources of heat or let it
come in contact with oil, solvents or sharp
objects.
5) Always be sure of your footing on slopes.
6) Walk, never run and do not allow yourself to
be pulled along by the lawnmower.
7) Mow across the face of slopes, never up and
down.
8) Exercise extreme caution when changing
direction on slopes.
9) Do not mow on slopes that are too steep.
10) Exercise extreme caution when pulling the
lawnmower towards you.
11) Stop the blade if the lawnmower has to be
tilted for transportation when crossing surfaces
other than grass, and when transporting the
lawnmower to and from the area to be mowed.
12) Never operate the lawnmower with defec-
tive guards, or without safety devices, such as
the stone-guard and/or grass-catchers, in
place.
13) On power-driven models, disengage the
drive clutch before starting the engine.
14) Start the engine carefully, following the
instructions and keeping feet well away from
the blade.
15) Do not tilt the lawnmower when switching
on the engine unless it is strictly necessary for
start-up. In this case, do not tilt it more than is
strictly necessary and only lift the part furthest
away from the operator. Check that both hands
are positioned correctly before lowering the
lawnmower.
16) Do not put hands or feet near or under rotat-
ing parts. Keep clear of the discharge opening
at all times.
17) Never pick up or carry a lawnmower while
the engine is running.
18) Stop the engine and disconnect the power
supply cable:
– before carrying out any work underneath the
C) OPERATION
CG rsb STIGA-71503804/0 22-12-2003 11:28 Pagina 53
54
ENGLISH
GB GB
cutting deck or before unclogging the chute;
– before checking, cleaning or working on
lawnmower;
– after striking a foreign object. Inspect the
lawnmower for damage and make repairs
before restarting and operating the lawnmower;
– if the lawnmower starts to vibrate abnormal-
ly, find and remove the cause of the vibration
immediately;
– whenever you leave the lawnmower unat-
tended.
– when transporting the equipment.
19) Stop the engine:
– every time you remove or replace the grass-
catcher.
– before adjusting the grass cutting height.
20) When mowing, always keep to a safe dis-
tance from the rotating blade. This distance is
the length of the handle.
1) Keep all nuts, bolts and screws tight to be
sure the equipment is in safe working condition.
Regular maintenance is essential for safety and
performance.
2) To reduce the fire hazard, keep the lawnmow-
er, especially the engine, free of grass, leaves,
or excessive grease. Do not leave containers
with grass cuttings in rooms.
3) Check the stone-guard and grass-catcher
frequently for wear and deterioration.
4) Periodically check the electric cables and
replace them if they are damaged or if the insu-
lation has been damaged. Never touch a badly
insulated cable if it still connected to the power
supply. Remove the cable from the socket
before taking any action.
5) Wear strong work gloves when removing and
reassembling the blade.
6) Check the blade’s balance after sharpening.
D) MAINTENANCE AND STORAGE
SERVICE
ACCESSORIES/SPARE PARTS
Always use genuine spare parts and
accessories. Non-genuine spare parts
and accessories have not been
checked and approved by the lawn-
mower manufacturer. Use of non-gen-
uine spare parts and accessories can
lead to the risk of injury even if they fit
the machine. The lawnmower manufac-
turer does not accept any liability for
injuries caused by the use of such parts
or accessories.
Genuine spare parts are stocked by authorised
service centres and by many dealers.
We recommend that you take the machine to an
authorised service centre for annual servicing,
maintenance and inspection of safety equipment.
For servicing and spare parts contact your distrib-
utor.
PRODUCT IDENTITY
The identity of the product is determined by the
article and serial numbers of the machine.
These can be found on the label fixed to the chas-
sis of the machine:
Use this identification whenever you contact a
service centre or buy replacement parts.
After buying the machine, write the above numbers
on the back page of this booklet as soon as possi-
ble.
The manufacturer reserves the right to make
changes to the product without prior notice.
THE ENVIRONMENT
In order to protect the environment, we recom-
mend that the following points should be given
special consideration:
• Do not dispose of used lead-acid batteries in a
garbage bin. Take them to a battery collection
point for recycling (applies to battery-powered
machines and machines with battery start).
• When, after many years of service, your
machine needs to be replaced or is no longer
required, we recommend that the machine is
returned to your distributor for recycling.
ART. NR
➔
SERIE NR.
CG rsb STIGA-71503804/0 22-12-2003 11:28 Pagina 54
55
ENGLISH
GB GB
CG rsb STIGA-71503804/0 22-12-2003 11:28 Pagina 55
56
ENGLISH
GB GB
CG rsb STIGA-71503804/0 22-12-2003 11:28 Pagina 56
GGP ITALY SPA • Via del lavoro,6 • I-31033 Castelfranco Veneto (TV) - ITALY
✍
CG rsb STIGA-71503804/0 22-12-2003 11:28 Pagina 70
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Stiga COLLECTOR 45S COMBI EL User manual
-
-
Stiga Collector 43S User manual
-
-
-
-
-
-
-
Other documents
-
Mountfield SP164 Operating instructions
-
-
-
-
-
-
-
Suffolk Punch SP15S Operating instructions
-
Atco Liner 19SEV Operating instructions
-
Mountfield SPL 410 User manual
