2. Atlas
  3. GSS-G

Atlas GSS-G, GST-G User manual

  • Hello! I am an AI chatbot trained to assist you with the Atlas GSS-G User manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
1/2
AtlasSound.com
TELEPHONE: (800) 876-3333
FAX (800) 765-3435
©2010 Atlas Sound L.P. All rights reserved. Atlas Sound is a trademark of Atlas Sound L.P. All other trademarks are the property of their respective owners. All specs are subject to change without notice. ATS002960 RevE 7/12
GSS-G & GST-G
Garden Speaker
1601 JACK MCKAY BLVD.
ENNIS, TEXAS 75119 U.S.A.
Key Features
• DownwardFiringSpeakerWillNotCollectDustorCondensation
• RuggedConstructionCanSupportUpTo250lbs
• EasyBayonetAttachmentofHeadUnitToBase,EnablesInstallation
ofBaseDuringExcavationandInstallationofHeadUnitAfter
LandscapingHasBeenCompleted
• SwitchSelectable70VInputorDirect8ΩInput(TransformerBypass)
• EasyConduitInstallationinTallandShortBaseWithDedicated
MountingPads
• SpeakerProtectedByTripleLayerGrille
• ShortBase(GSS-G)hasDrillPointsfor4"Square,2-GangEOBox,or
1-GangBoxMountingtoaDeckorSlab
Instructions
To Install GST-B Tall Base Unit:
1. Makesureyouhaveapathtoburywireconnectedtospeaker.
2. Digahole8"deepx30"diameter.
3. Runwiretohole.
4. Attachconduitorglandnuttoflatsonbase.
5. Bringinwireandleavesufficientcableforadequateserviceloop
(minimum18")toreachheadunit.
6. Fillbasewithcleandirtorsandtowithin2"-3"oftopforoptimum
bassperformance.
7. Coverwithprovidedtemporarylidandattachwithprovided
1"screwsifheadunitisnottobeattachedimmediately.
8. Backfilldirttobase.Topofbaseshouldbe2"–3"aboveground.
To Install GSS-G Short Base Unit:
If Using an EO Box:
1. Install1-Gang,2-Gang,or4"x4"boxflushtomountingsurface.
2. Cutoutscribedlineonbottomofbasefor1-or2-gangbox.
3. Drillappropriateholesinbase(outer4holesfor4"x4",inner4for
2-gang,or1setof2innerfor1-gang).
4. Installwiringinbox.
5. Setbaseonboxandattachwithscrews.
If Using Conduit:
1. Mountbasetosurfacewithappropriatescrewsthroughthebase
bottom.
2. Attachconduitandbringinwire.Provideforsurfaceloop
(minimum18").
3. Coverwithprovidedtemporarylidandattachwithprovided1"screws
ifheadunitisnottobeattachedimmediately.
GST-G
Tall Base
GSS-G
Short Base
2/2
AtlasSound.com
TELEPHONE: (800) 876-3333
FAX (800) 765-3435
©2010 Atlas Sound L.P. All rights reserved. Atlas Sound is a trademark of Atlas Sound L.P. All other trademarks are the property of their respective owners. All specs are subject to change without notice. ATS002960 RevE 7/12
GSS-G & GST-G
Garden Speaker
1601 JACK MCKAY BLVD.
ENNIS, TEXAS 75119 U.S.A.
To Install Head Unit on Base:
1. Removetemporarycover,ifpresent.Retainscrews.
2. Attachthepurplewirefromtheheadunittothepositiveinputwire
andtheblacktothenegative.
3. Lineupthe3“feet”ontheheadunitwiththeholesinthebase.
4. Pushtheheadunitdownintotheholesandturnclockwisetolockthe
headunitinplace.
5. Puta1"Phillips-headscrew(suppliedwiththebase)through
thelockingscrewaccessholetosecureandpreventremovalby
unauthorizedpersons.
6. Putstick-onlogocoveroveraccesshole.(SeeFigure1)
7. Selecttransformertapwattageor8Ωinputpositionusingadimeor
smallscrewdrivertoadjuststeppedswitch.(Switchislocatedonthe
undersideofthe“domed”sectionoftheheadunitnearouteredge.)
Insertredweatherprotection“plug”intorecessedswitchcavity
usingthumbtopressthecapintoplace.(SeeFigure2)
Garden Speaker Specifications
FrequencyResponse 43Hz–20kHz(±7dB)
Sensitivity(1W/1M) 89.5dB(HalfSpaceReference)
PowerHandling 70WattsRMS
HorizontalDispersion 360°
Speaker Coaxial8",Polypropylene/KevlarConewith
RubberSurround,
1
⁄2"MylarDomeTweeter,
1
1
⁄2"VoiceCoil,21ozMagnet
Transformer 8,16,&32Watts,withanExternalSwitchfor
TapSelectionandforBypassingTransformer
Dimensions
TallBaseWidth 17
5
⁄8"(448mm)
TallBaseLength 17
5
⁄8"(448mm)
TallBaseHeight 20
7
⁄8"(531mm)
ShortBaseDiameter 15
1
⁄8"(384mm)
ShortBaseHeight 13
1
⁄8"(334mm)
HeadUnitWeight 13.2lbs(5.99Kg)
ShortBaseWeight 2.4lbs(1.09Kg)
TallBaseWeight 6.4lbs(2.9Kg)
Figure 1
Figure 2
Speaker
Head Unit
/