Amana ACS200 Series Installation Instructions Manual

Amana
Brand
Amana
Model
ACS200 Series
Category
Barbecues & grills
Type
Installation Instructions Manual
Sealed Burner
Module
Installation
Instructions
ACS200*
* Additional alphanumeric characters representing other
models in series may follow each model number.
Please Read Manual Before Operating
Installer
Leave this manual for consumer’s and local electrical
inspector’s use.
Customer
Keep these instructions for future reference. If appliance
changes ownership, be sure this manual accompanies
appliance.
English........................................................................ 2
Español ...................................................................... 4
Français ..................................................................... 6
2
Correct
Not centered
Too small
Too large
6. Ignite burner according to instructions in range or
cooktop Use and Care, or Owner's Manual. Properly
adjusted burner flames are clean and blue with a
distinct inner cone approximately ½ inch long.
• Burner should ignite within 4 seconds. If burner does
not ignite within 4 seconds turn control knob to
OFF
position and follow directions in step 5. Try burner
again. If burner still does not ignite in 4 seconds,
contact an authorized servicer.
• If burner flame is blowing or noisy, or if burner flame is
yellow and does not hold its shape, see "Adjusting
Burner Flame" section.
A
Burner
Inner cone
A—¼ inch to ½ inch long
7. Replace burner grate when flame is properly adjusted.
Sealed Burner Module
Installing Module
WARNING
To avoid risk of personal injury, all controls must be in
OFF
position before removing or installing
1. Turn controls to
OFF
position.
2. Remove grate and burner caps from module.
3. Place end of module into range or cooktop well with air
shutters facing rear of well.
• If grease pan from grill or griddle module is in well,
remove before installing burner module.
Front
Rear
Well
4. Slide module towards rear of range or cooktop until
module engages. Lower front of module into well.
5. Place burner caps on burner base.
• Pegs in the burner base fit into recess in underside of
burnercap. To make sure cap is properly aligned and
leveled, move burner cap around on burner base.
Burner cap must be correctly seated on burner base
for proper operation of burner.
• Make sure proper cap size is on each burner base.
Burner does not burn properly if wrong size burner cap
is placed on burner base.
3
Removing Module
WARNING
To avoid risk of personal injury, all controls must be in
OFF
position before removing or installing
1. Turn controls to
OFF
position.
2. Remove grate and burner caps from module.
3. Lift module up and slide out while holding
by front tab.
4. After module clears orifices, remove module
from range or cooktop.
Adjusting Surface Burner Flame
Properly adjusted burner flames are clean and blue with a
distinct inner cone approximately ½ inch long.
A
Burner
Inner Cone
A—¼ inch to ½ inch long
1. Turn controls to
OFF
position.
2. Remove grate and burner caps from module.
3. Remove module according to “Removing Module”
section.
4. Locate air shutters on rear of module.
Air Shutters
5. Adjust each air shutter using small screw driver.
• Slide air shutter until fully open if range or cooktop is
set for LP/Liquid Propane gas.
• Slide air shutter until shutter is approximately
1
/8 inch open if range or cooktop is set for natural gas.
Shutter
6. Replace module according to “Installing Module” section
and check for proper flame.
• If burner flame is blowing or noisy, remove module and
reduce air flow by closing shutter.
• If burner flame is yellow and does not hold its shape,
remove module and increase air flow by opening air
shutter.
7. Replace burner grate when flame is properly adjusted.
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Part No. 36-31812001-0
Printed in U.S.A.
1997 Amana Appliances
Amana, Iowa 52204
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8

Amana ACS200 Series Installation Instructions Manual

Amana
Brand
Amana
Model
ACS200 Series
Category
Barbecues & grills
Type
Installation Instructions Manual
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

in other languages

Related papers

Other documents