INSTRUCTION MANUAL
Please read this manual carefully before using, and keep it for future reference.
GEC-11
GENERAL SAFETY 4
PRODUCT OVERVIEW 8
CONTROL PANEL & SETTINGS 9
OPERATION 11
HOW TO CLEAN 13
TROUBLESHOOTING 14
SPECIFICATION 15
CUSTOMER SUPPORT Last Page
CONTENTS
4
Read this manual thoroughly before you start using the product.
Store this manual, the completed warranty card, your receipt and
the product packaging.
The safety precautions instructions reduces the risk of fire, electric shock
and injury when correctly complied to.
Please follow all instructions and take notice of all warnings.
Please follow instruction when installing this product in accordance with
the instructionmanual. This product must be positioned in a suciently
stable location, it can be potentially hazardous due to falling when mounted
and can cause injury, particularly to children if it positioned incorrectly.
• Before installing this product, make sure your outlet voltage corresponds
to the voltage stated on the power supply rating label.
• Do not use a damaged power cord, plug or loose outlet. Doing so may
cause an electric shock.
• Do not plug several devices into the same outlet. Doing so may cause
the outlet to overheat and start a fire. Make sure the outlet is readily
accessible during operation of the equipment.
• Do not bend, twist or kink the power cord excessively.
• Do not allow anything to rest on or roll over the power cord. Doing so
may cause a fire or an electric shock.
• Do not run the power cord near heat-producing appliances such
as radiators, stoves or irons. The excessive heat could melt the insulation
and expose live wires, resulting in fire or electric shock.
• Do not expose the product to water. The electrical insulation could be
damaged and cause electrocution. Do not touch the unit when barefoot
or parts of your body are wet or damp.
• This appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for
their safety. Children should be supervised to ensure that they do not
play with the appliance.
• If the supply cord is damaged, it must be replaced by the manufacturer,
its service agent or similarly qualified persons in order to avoid a hazard.
• Do not cover the ventilation openings of the product with items such as
newspapers, tablecloths, curtains etc or insert objects into the slots
available on the products. As this could result in the product temperature
rising and could cause a fire.
GENERAL SAFETYGENERAL SAFETY
5
GENERAL SAFETYGENERAL SAFETY INSTRUCTIONS
(Cont.)
• If you notice any unusual odors or smoke around the unit, immediately discon
nect the unit from the outlet and contact the service center. Failure to do so may
result in fire or electric shock.
• When not using the unit for long periods of time or when you are moving the
unit please ensure to disconnect the power supply from the wall socket.
• Please beware that Dust could accumulate over time on the unit and cause it to
generate heat and or deteriorate insulation, which in turn may result in an
electrical fire.
• Batteries from the remote control must be only removed by an adult, the adult
must ensure to keep them out of reach of infants and children. Seek medical
attention immediately if a child has swallowed a battery.
• To maintain the product do not use any chemical or cleaning agent or wet cloth,
please only ensure to utilize a dry cloth to wipe it down from marks or dust and
only after unplugging the product from the power socket.
• Do not direct airflow directly onto plants or animals, as long exposure can aect
them.
• Please ensure to contact our call center for any repair or service required for the
products not doing so will make warranty on your product void.
• We assume not liability for any eventual damages to property or injury to
persons caused by misuse of the product or noncompliance with these
instructions.
Please make sure upon positioning this product, the place is:
• Not wet or damp and Well ventilated
• Away from direct sunlight or heaters.
• Away from splashes or food.
• Protected from excessive dust or grease.
• Do not place small metallic objects on top of the unit or block the openings
as it will reduce operating eciency of the air con with failures or damages.
6
• This appliance is intended for air conditioning indoor domestic environ
ments. It is not suitable for commercial, industrial or trade use.
Do not use it for any other purpose (such as drying clothes, cooling food,
etc.), and only use it as described in this manual.
• Do not use the unit outdoors. It is for indoor use only.
• Do not insert any objects, or your fingers, into the air outlet, and make
sure to warn children of the dangers. Keep ventilation openings clear
of obstructions.
• Supervise children to ensure they do not play with the appliance.
Close supervision is necessary when any appliance is used by or near
children. Cleaning and user maintenanceshall not be made by children
without supervision.
DO NOT INSTALL/USE THE APPLIANCE IN THE FOLLOWING AREAS:
- outdoors or where water is likely to splash
- near a bath, shower, laundry basin or swimming pool
- in an area where oil is likely to splash
- near a hot gas or electric burner, or sources of fire
- near sources of heat, or exposed to direct sunlight
- in an area where furniture or other objects can obstruct the airflow
- in the presence of flammable substances or vapour such as alcohol,
insecticides, petrol, etc.
- at a dry cleaner’s premises.
GENERAL SAFETYGENERAL SAFETY INSTRUCTIONS
(Cont.)
7
GENERAL SAFETYGENERAL SAFETY INSTRUCTIONS
(Cont.)
WARNING:
• Do not expose the appliance to high heat, sparks and open flames.
• Do not pierce or burn the appliance.
• Maintenance must only be carried out by properly qualified, authorised
personnel. If the appliance requires maintenance or service, contact our
after sales support centre info@ayonz.com
ELECTRIC SHOCK HAZARD!
Before installation, cleaning or or servicing, ensure the unit is
switched o and disconnected from the power outlet to prevent
possible injury.
8
PRODUCT OVERVIEW
1. Control panel
2. Louver
3. Water level indicator
4. Castor Wheel(4pcs)
5. Water tank
6. Power Cord
7. Water filling box (for filling water and ice)
8. Back cover
9. Air filter
10. Water drainage outlet
11. Handle
(Fig. 1)
9
Control Panel Layout
A. ON/OFF: Connect the unit to a power source and press the
button once to start air cooler. Press again to Power OFF the
air cooler. When cooler is plugged into the main socket, The
LED will light be indicating the air cooler now have power and is
ready to be switched ON or OFF.
B. SWING: Press once, the indicating LED will light, louver of the
air cooler begins to swing horizontally and blow cool air. Push
the button again, the LED is now OFF. The louver of air cooler
stops swinging, and air is blowing in one direction.
C. SPEED: Press to change fan speed from “High-Mid-Low”,
relative SPEED indicator LED lights on. SPEED function
High-Mid-Low and be used in-conjunction with the SLEEP
and Natural function.
D. TIMER: can be set the length of time before the cooler switches
itself OFF. Press once for every 0.5hr increments. Maximum
allowable is 7.5hrs. Example of use, if 0.5hr and 1.0hr lights on at
the same time, it means timer is set 1. 5hrs before automatically
switching OFF. The TIMER function is OFF when no LED are light up.
CONTROL PANEL & SETTINGS
10
E. COOL MODE: Press once to operate the COOL function. This
function begins the process of soaking the water curtain in water so
that normal air passing through the water curtain will be cooler when
blown out. Press the button again to switch this function OFF, and the
unit will operate the fan mode only.
Note: Please fill enough water into the water tank before using this
function.
F. MODE: There are 3 mode functions, Normal, Natural or Sleep.
- Normal mode: Constant air flow and can be adjusted via pressing
the SPEED function button. Example, Normal LOW or Normal High
or Normal Medium.
- Natural mode: Programmed to simulate Natural air flow (wind) as
if it was entering via the window. This mode is preferred for use when
constant air flow (Normal mode) is not suitable. Natural mode can
be operated HIGH or MEDIUM or LOW speed.
- Sleep Mode: Programmed to provide comfort while the user is
asleep. This mode is like the Natural mode and can operate with
SPEED mode HIGH or MEDIUM or LOW.
NOTE: All of the above can be operated via the remote control.
CONTROL PANEL & SETTINGS
11
1. Ensure that the cap on the Water drainage outlet of the unit is tight.
Pour clean cold water into the water filler area, observing the water
level indicator in the bottom front panel.
Do not overfill past the MAX water indicator mark. If desired,
place ice in the ice compartment in the top of the unit.
CAUTION:
• Do not spill or allow water to come in contact with the
control panel
• Do not pour water into the ice compartment.
• Do not allow the combined use of water and ice to overfill
the water reservoir.
• When moving the unit, do so with extreme caution, so as not to
spill any water in the reservoir. The unit should be moved slowly
and in a sideways direction.
• Always keep the unit upright.
2. Connect the unit to a power outlet of the same voltage and
frequency as indicated on the rating plate. The unit ON/OFF LED
for the power will light to indicate that there is power to the unit.
3. Turn the unit ON by pressing the ON/OFF button. The unit will
start and then revert to the initial Normal / LOW speed setting.
Further operation can be performed via pressing the SPEED,
MODE, TIMER, COOL and SWING buttons.
4. If you wish to turn the unit o at a pre-determined time depress the
TIMER button. The unit can be set to turn o at any time between
0.5 hour and 7.5 hours from “Turn On” by pressing the TIMER button.
If no time is selected, the unit will operate continuously. The time set
can be incremented in 0.5hr steps and the selected time is indicated
by a combination of indicator lights. E.g., 5.5hrs isindicated by the
4hr LED, the 1hr LED and the 0.5hr LED being illuminated.
OPERATION
12
5. To initiate the cooling function depress the COOL button. It will take
approximately minutes for the air to cool.
NOTE: If this button is not depressed the unit will only circulate “room
temperature” air.
6. Move the horizontal louver for the air outlet to blow up or down to
suit.
7. The vertical louvres can be set in a direction or allowed to rotate
by depressing the SWING button.
8. All the functions can be performed with the remote control
supplied with this unit.
a) Remove battery cover and install two “AAA” batteries (not included)
as indicated. (Please observe correct battery polarity.)
b) Point the remote towards the unit and press the appropriate button.
The remote control will operate up to 4 meters from the unit.
9. Depress the OFF button to cancel all functions.
10. When not in use disconnect the unit from the power outlet and
drain all water from the water reservoir. (See HOW TO CLEAN)
NOTE: Initial setting is “normal” mode and “low” speed and will occur
every time the plug into plugged into the power main.
Once the cooler has been set to desire function/s, the cooler
will keep memory of the setting as long as there is power to
the cooler (step 2) when it is switched OFF, and without
unplugging the plug from the power main.
Please refer to “installation and use” to learn the operations of the
MODE function (NORMAL, NATURAL, and SLEEP)
OPERATION
13
To ensure eective humidifying and filtering, it is recommended
that the filtering system be cleaned once every 1-2 months
HOW TO CLEAN
Screws
Back cover
Water Drainage outlet
have to empty the water collector a few times, finally recap
the plug of the water drainage outlet.
3. It is recommended that the filter be cleaned once every week.
The air filter is connected into the back cover via two clips at the
top. Release by pressing the two clips down and give it a little
push. Care full not to damage the filter.
CAUTION: Do not immerse or allow the motor or electric cables to
meet any liquid.
4. To clean the exterior surfaces simply wipe over with a soft damp
cloth. Should it be necessary, greasy marks may be removed
from the surfaces by using mild soap and a cloth dampened in
hot water. Avoid all other types of detergents, cleaners, solvents
that may contain chemicals which could damage parts of the
unit. Thoroughly dry all parts before storage.
5. Store in a cool dust-free location for next use.
1. Disconnect the unit
from the mains
supply.
2. Empty the water
reservoir by loosening
the plug of the water
drainage outlet.
Make sure you have
a container under the
drain to collect the
water or empty the
unit outside. You may
14
TROUBLESHOOTING
Always check full product operation as detailed above before returning
If you experience problems with your product, or it appears
not to be operating correctly, check the information below for solutions
to common problems. If none of the solutions oered help you solve
your problem, please contact our support centre for advice on
info@ayonz.com
Do not attempt to repair the appliance yourself!
15
SPECIFICATIONS
Rating voltage frequency
Input power
Water consumption
220-240V~ 50-60Hz
70W
0.5-1.5L/h
CUSTOMER HELPLINE:
info@ayonz.com
DISTRIBUTED BY:
Ayonz Pty Ltd
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Germanica GCFH300W User manual
-
Germanica GCH1500W360 User manual
-
Germanica GR3IN1MC User manual
-
Germanica GFH2000 User manual
-
Germanica GFF-20 User manual
-
Germanica GHO2000CWB-2 User manual
-
Germanica GRTFWR1 User manual
-
Germanica GCF-15 User manual
-
Germanica GSC-1050R User manual
-
Germanica GETH2000W User manual
