Sealite SL-70 Quick start guide

  • Hello! I am an AI chatbot trained to assist you with the Sealite SL-70 Quick start guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Introduction
The SL-70 is a high-performance solar marine lantern with a visible range of 2-3NM. The SL-70 is unique in its proven ability to operate reliably in low
sunlight conditions due to dual high-performance solar panels for maximum sunlight capture. GPS synchronisation is offered as an option on this model.
Quick Start Guide
SL-70, 2-3NM+ Solar Marine Lantern with IR Controller
Installation Parts
Setting up the SL-70 marine lantern
1. Remove the SL-70 Lantern, the Switch Key and IR Controller
(available as an option) from their packaging.
2. Use the switch key to remove the SL-70 bung to access the
ON/OFF toggle switch. Refer to Diagram 1.
3. Use the switch key to switch ON the SL-70.
4. Place the SL-70 bung back on the base.
Pre-installation check
Sealite Pty Ltd
Australia
+61 (0)3 5977 6128
Sealite Asia Pte Ltd
Singapore
+65 6829 2243
Sealite United Kingdom Ltd
UK
+44 (0) 1502 588026
Sealite USA LLC
USA
+1 (603) 737 1311
We believe technology improves navigationTM
SL-70 Marine
Lantern
Switch
Key
IR
Controller
(optional)
T/CT/C
Read Lux
Flash Code Intensity Battery Status
Test / Congure
1 2 3
4 5 6
7 8 9
R0L
FC I B
Lux D-N Lux N-D
1. The factory default setting of the SL-70 is 0.5 seconds ON
and 4.5 seconds OFF with operating mode of Dusk till Dawn.
The lanterns flash character can be changed by using the
switch key to adjust the rotary switches on the lantern
base. Alternatively, adjustments can be made using the IR
programmer.
Download the user manual for alternate settings.
2. To activate the lantern for testing, ensure the lantern is in
darkness for 30 seconds. The SL-70 should begin flashing.
In the event the lantern does not begin to flash, ensure
the unit is in adequate darkness and check the battery
connection.
3. Once the lantern has started to flash, expose the lantern to
light and within 30 seconds the SL-70 should stop flashing.
Charging the Battery
For optimal performance, new lanterns should be left in full sun
for 1-2 days for the battery to charge, prior to installation.
Preferred Installation Location
For best lantern performance, ensure solar modules are not
covered or in shade. Lanterns exposed in clear view of the sky
will result in optimum charging results.
4
5
6
7
8
9
A
B
C
D
E
F
0
1
2
3
4
5
6
7
8
9
A
B
C
D
E
F
0
1
2
3
AB
ON
OFF Rotary
Switch A
Rotary
Switch B
Intensity Setting
ON / OFF
Switch
User Replaceable Battery
Diagram 1 - Lantern Base
A complete user guide is
available to download from
the Sealite website.
Visit: sealite.com
/