GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
WARNING: ALL NON-TRAILER LOADS APPLIED TO THIS PRODUCT MUST BE SUPPORTED BY 18050 STABILIZING STRAPS.
** FAILURE TO PROPERLY SUPPORT NON-TRAILER LOADS WILL VOID PRODUCT WARRANTY**
HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT 1-800-798-0813
HITCH WEIGHT: LBS.
INSTALL TIME
PROFESSIONAL: MINUTES
NOVICE (DIY): MINUTES
INSTALL NOTES:
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
3,500 300
29
60
87-95 NISSAN PATHFINDER
6/3/2010
12109
120
367200
Parts List DESCRIPTION
PART NUMBER
QTY
ITEM HEX BOLT7/16-14 x 1 1/2
61 WASHER
7/1622 U-BOLT7_16 - 14 x 3.25 x 2.50 C-C SQ. U-BOLT23 HEX FLANGE NUT7/16-14104.250" BACKING PLATECM-12109-BP2
5.25 x 1.75 x 2.00 SPACERCM-SP10226 .125 x 1.00 SPACERCM-SP104
47
1. At the rear of the vehicle, examine for brackets as shown in the diagram. Remove the vehicle's bracket on
each side that connects to the bottom of the frame rail with the bumper brackets. Existing 12mm fasteners
will be reused at the top of the hitch.
2. The hitch will bolt to the bottom of the frame rails and the bumper brackets where the brackets were removed.
Install fastenes as shown.
3. Install CM-12109-BP plates provided using rectangular U-bolts and fasteners at the hitch cross tube to
connect the hitch to the vehicle's (2) tie down brackets. These plates should connect at the flat side of the
tie down brackets as shown.
4. Torque all 7/16" fasteners to 50 lb-ft.
NOTE: Do not use impact wrench on U-bolts.
2 1
3
EXISTING 12mm
SCREW PLATE AND NUT
(BOTH SIDES)
DRIVER SIDE
FRAME RAIL
PASSENGER SIDE
FRAME RAIL
- NO DRILLING REQUIRED
- REMOVE BRACKETS
4
6
7
5
DESIGNED FOR USE WITH
BALL MOUNT # D-55003 / 45503
-
1
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Curt Manufacturing 11546 Owner's manual
-
-
-
-
-
Other documents
-
CURT 121073 Installation guide
-
-
-
-
-
-
-
-
-