2. Front Runner
  3. RRAC052

Front Runner RRAC052 Installation guide

  • Hello, I'm your chat assistant. I have reviewed the user manual for the FRONT RUNNER Surf Board Carrier RRAC052. This manual provides step-by-step instructions for installing the carrier on your rack. I see that the manual mentions the use of M8 bolts, washers, and nyloc nuts for secure fastening. I'm ready to assist with any questions you might have regarding the setup process or the features described.
  • What tools do I need for installation?
    How many carriers are in a set?
    What type of bolts are used?
1
Pro surf, Windsurf &
Paddle Board Carrier
RRAC052
INSTALL TIME: 5 Mins
REV_A01
FIT your Surf Board CARRIERS
You will need:
13 mm Flat Wrench
( )
A
Decide where on your Rack you would like to place your set of four Carriers. Work out the correct spacing
for the length of your Board. Slide four M8 x 16 Hex Bolts into the T-slot of each of the two corresponding
Slats through the machined slot as shown. Place each Carrier over two Hex Bolts, with the cut out in the
foam towards the inside of the rack as shown. Loosely fasten the four Carriers to the Rack using the M8
Flat Washers and M8 Nyloc Nuts supplied. Position the four Carriers left to right as required and fasten all
the Nyloc Nuts. Place a M8 Nut Cap over each of the Nyloc Nuts.
Secure your Board using the Stratchits supplied. The Stratchits are attached to the Carriers on the cross
bar as indicated.
Congratulations, you have completed your installation. Take a step back and admire your work. Good Job!
( )
B
/