Neutrik NP2 X-AU Silent Klinkenstecker Operating instructions
- Category
- Networking cables
- Type
- Operating instructions
This manual is also suitable for
Slide the boot onto the cable.
Solder the wire ends.
Position the chuck onto the cable and align chuck
with plugfinger.
Slide the housing onto the plugfinger with the
chuck.
Finish the installation by tighten the bushing onto
the connector.
Attention:
Attention:
Solder shield to marked position.
If using a cable with O.D. > 5.50 mm [0.216”] break
away this part of the chuck.
Prepare cable as shown.
A
B
C
E
F
D
NEUTRIK AG
NEUTRIK Zürich AG
NEUTRIK USA Inc.
NEUTRIK UK Ltd.
T: F:
T: F:
T: F:
() T: F:
LI
CH
USA
UK
+423 / 237 24 24 +423 / 232 53 93
+41 44 / 736 5010 +41 44 / 736 5011
+1 732 / 901 9488 +1 732 / 901 9608
+44 1983 / 811 441 +44 1983 / 811 439
Draft. Nr.: BDA 218-0 Update: 06.03.2008/ 3102M1641 II
Data subject to change without prior notice. 2008NEUTRIK . ALL RIGHTS RESERVED.©®
NEUTRIK
NEUTRIK France
NEUTRIK Tokyo Ltd.
NEUTRIK
Vertriebs GmbH T: F:
T: F:
T: F:
Ltd. T: F:
DE / NL / AT
FR
JP
HK
+49 8131 / 280 890 +49 8131 / 280 830
+33 1 / 4131 6750 +33 1 / 4131 0511
+81 3 / 3663 4733 +81 3 / 3663 4796
+852 / 2687 6055 +852 / 2687 6052
Hong Kong
ASSEMBLY INSTRUCTION
www.neutrik.com
NP2X-AU-SILENT 1/4” Professional Phone Plug
|
A
B
C
D
E
F
16
4
[0.63”][0.63”]
[0.16”][0.16”]
6
[0.24”][0.24”]
1. 2.
break off
Shield
Tip
Position to solder
the shield.
1.
2.
SILENT
SILENT
-
1
Neutrik NP2 X-AU Silent Klinkenstecker Operating instructions
- Category
- Networking cables
- Type
- Operating instructions
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Neutrik NJ3FC6 Installation guide
-
-
-
-
-
-
-
-
-
