Generation Lighting 8338751 Operating instructions

8338751
Brand
Generation Lighting
Model
8338751
Type
Operating instructions

This manual is also suitable for

Installation Instructions for
Sevier Downlight Outdoor Wall
990W83387_1-SEV
8338701, 8338751
1.0
WALL
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing compliantNEC
junction boxes.
This product is safety listed for wet locations.
Incandescent version may be dimmed with a standard incandescent
dimmer. version may be dimmed with a dimmer. ConsultLED LED
lamp manufacturer for additional information.
This instruction shows a typical installation.
CAUTION RISK OF FIRE-
This product must be installed in accordance with the applicable
installation code by a person familiar with the construction and
operation of the product and the hazards involved.
Use minimum 90°c supply conductors.
7400 Linder Ave, Skokie, 160077IL
800.969.3347
www.generationlighting.com
© 2020 Generation Lighting.All rights reserved.
The "Generation Lighting" graphic is a registered trademark of
Generation Lighting. Generation Lighting reserves the right to
change specifications for product improvements without notification.
SAVETHESE INSTRUCTIONS!
2
Secure the mounting plate to the junction box.
Install the frame to the fixture using the two frame screws.
Screw the lamp into the socket. Refer to the label on the socket for Max Wattage Information.
Connect the fixture to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire to the neutral power line wire with a wire nut.
Connect the black fixture wire to the hot power line wire with a wire nut.
Align and place the fixture base onto the mounting studs, then secure it with the washers and cap nuts. NOTE: Use the
swivel on the mounting plate to adjust position as necessary.
Screw the lamp into the socket. Refer to the label on the socket for Max Wattage Information.
For wet locations, caulk around the base of the fixture with waterproof construction sealant.
1
2
3
4
5
6
7
Install the Fixture
8
1A
LAMP
SOCKET
5
MOUNTING
STUD
MOUNTING
PLATE
JUNCTION BOX
FIXTURE
BASE
WASHER &
CAP NUT
3
7
6
7
SWIVEL
FRAME SCREW
9
9
2
  • Page 1 1
  • Page 2 2

Generation Lighting 8338751 Operating instructions

8338751
Brand
Generation Lighting
Model
8338751
Type
Operating instructions
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents