![](//vs1.manuzoid.com/store/data-gzf/fcb46f07e567f5fa5de2b6ab21dbbddd/2/001999975.htmlex.zip/bg1.jpg)
Re-calibrate settings and change the minimum light level.
Disconnect power at the breaker box
then remove wall plate.
Lower the slider to the minimum
setting (as shown).
Use a small, insulated flat head
screwdriver to move the calibration
wheel all the way up towards the
“–” sign.
Turn wheel down towards the “+”
sign in small increments until the
flickering is gone.