Product Installation
2. Punch a hole with
the punch tool .
3. Insert the cap through the
hole, and then cover the
socket on it.
4. Place the convex tool
vertically on the socket,
strike with a hammer.
5. Punch a hole with the
punch tool again.
6. Insert the post through
the hole. Put the stud
over the post.
7. Place the concave tool
vertically on the cap, pound
lightly with a hammer.
8. Finish up by testing each
button to make sure they
are correctly installed.
1. Prepare 4 parts: cap,
socket, stud and post.
A
R