Page is loading ...
-
MPN: OTDGYMv2
SKU: 400503
UPC: 719318367469
2
KEY #
DESCRIPTION
QTY
(1)
MAIN SUPPORT TUBE
x2
(2)
TOP SUPPORT TUBE
x1
(3)
TOP LAT TUBE
x2
(4)
LOW SUPPORT TUBE
x1
(5)
LOW CONNECT TUBE
x2
(6)
PULL BELT
x2
(7)
PLASTIC BOARD
x1
(8)
M10x60 BOLT
x10
(9)
M6x50 BOLT
x2
(10)
Φ6 WASHER
x2
(11)
Φ10 WASHER
x20
(12)
M6 NYLON LOCK NUT
x2
3
1. Line up each end of the PLASTIC BOARD (7) with a MAIN SUPPORT TUBE (1), and secure
each end with an M6x50 BOLT (9), Φ6 WASHER (10), and an M6 NYLON LOCK NUT (12).
When tightening the nut and bolt combinations, you may need to apply pressure to the
heads of the M6x50 BOLTS (9) with your finger in order to achieve adequate tightness.
2. Place the TOP SUPPORT TUBE (2) and the TOP LAT TUBES (3) atop the MAIN SUPPORT
TUBES (1), and secure them with M10x60 BOLTS (8) and Φ10 WASHERS (11).
STEP 1
STEP 2
4
3. Hook the LOW CONNECT
TUBES (5) onto the MAIN
SUPPORT TUBES (1). The
LOW CONNECT TUBES (5)
should be hooked on the
side of the TOP SUPPORT
TUBE (2) that is farthest
away from the TOP LAT
TUBES (3).
4. Secure the LOW SUPPORT
TUBE (4) toward the bottom
of both LOW CONNECT
TUBES (5) with M10x60
BOLTS (8) and Φ10
WASHERS (11).
STEPS 3–4
5
5. Slide the loops of the PULL BELTS (6)
over the ends of the LOW SUPPORT
TUBE (4).
TIP: This product can be widened by rotating
the center portion of the LOW SUPPORT
TUBE (4).
STEP 5
TIP
/
