Step 4. Next, install the (x6) M8x25mm Hex bolt and flanged nuts through the pinch weld and
bracket and finger tighten for now.
Step 2. Remove the factory running boards and discard.
Step 3. With an assistant or use of jack stands, install the slider using the supplied M8x30mm hex
bolt (x3) to the upper mounts first and loosely tighten for now.
Step 5. After finial adjustment, tighten the (x3) upper mounts first to 18-20 (ft./lbs.) and then the
pinch weld (x6) hardware to 18-20(ft./lbs.)
Step 6. Repeat steps 2-5 with passenger side.
*** Your install is now complete***