2. BLOTZ
  3. B28-ST-130

BLOTZ B28-ST-130 Assembly Instructions

  • I have reviewed the instructions for the BLOTZ Street Lamp model B28-ST-130. This document outlines the steps required to assemble the laser-cut wooden parts, including the pole, base, discs, and shades. I'm ready to answer your questions about the assembly process, the tools needed, and other aspects of the device.
  • What kind of glue is required to stick the sections together?
    What tool is needed to remove sections from the sprue?
    What can be used to clean the joints?
28mm Street Lamps
B28-ST-130
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Each lamp is made from the pieces shown above.
Carefully slide the five circles onto the lamps pole.
Glue the end of the pole into the base, then slide the
discs back down the pole and glue them into position.
Using the hole cut in the smaller lampshade, slide it
over the whole shade.
Align the smaller shade at 90 degrees to the main
shade, then slide it downwards so the notch in its base
is snug against the base of the main shade.
The finished lamp.
/