Skov Surveillance cameras Technical User Guide

Brand: Skov

Model: Surveillance cameras

Type: Technical User Guide

This manual is also suitable for

130492

Surveillance Cameras

Technical User Guide

604505 • 2022-06-13

Surveillance Cameras

2 Technical User Guide

Product and Documentation Changes

SKOV A/S reserves the right to change this document and the product herein described without further notice.

In case of doubt, please contact SKOV A/S.

The date of change appears from the front and back pages.

Note

• All rights belong to SKOV A/S. No part of this manual may be reproduced in any manner whatsoever without

the expressed written permission of SKOV A/S in each case.

• All reasonable efforts have been made to ensure the accuracy of the information contained in this manual.

Should any mistakes or imprecise information occur in spite of this, SKOV A/S would appreciate being noti-

fied thereof.

• Irrespective of the above, SKOV A/S shall not accept any liability with regard to loss or damage caused or

alleged to be caused by reliance on any information contained herein.

• Copyright by SKOV A/S.

Surveillance Cameras

1 Product description ....................................................................................................................................... 4

2 Product survey ............................................................................................................................................... 5

2.1 Accessories................................................................................................................................ 5

3 Mounting guide............................................................................................................................................... 6

3.1 Recommended tools.................................................................................................................. 6

3.2 Mounting the surveillance camera ........................................................................................... 7

4 Installation guide............................................................................................................................................ 8

4.1 Electrical connection................................................................................................................. 8

4.1.1 Bandwidth requirements for the Internet connection ................................................................... 8

4.1.2 Cabling......................................................................................................................................... 8

4.1.3 Cable plan.................................................................................................................................... 8

4.1.4 PoE switch ................................................................................................................................... 9

4.1.5 Connecting the LAN cable ......................................................................................................... 10

4.2 Setting up the surveillance camera........................................................................................ 12

4.2.1 Credentials and IP Scheme ....................................................................................................... 12

4.2.1.1 iVMS4200 account..................................................................................................................... 12

4.2.1.2 Hik-connect account .................................................................................................................. 12

4.2.1.3 Camera configuration................................................................................................................. 12

4.2.2 Installing the iVMS4200 program............................................................................................... 13

4.2.3 Start-up of iVMS4200 user......................................................................................................... 14

4.2.4 Configure the iVMS4200 program ............................................................................................. 17

4.2.5 Hik-Connect App........................................................................................................................ 21

4.2.6 FarmOnline Explorer widget ...................................................................................................... 22

5 Maintenance instructions ............................................................................................................................ 23

5.1 Cleaning.................................................................................................................................... 23

5.1.1 Surveillance camera .................................................................................................................. 23

5.2 Recycling/Disposal .................................................................................................................. 23

6 Trouble shooting instructions .................................................................................................................... 24

7 Technical data .............................................................................................................................................. 25

Technical User Guide

Surveillance Cameras

4 Technical User Guide

1 Product description

Surveillance cameras are used as additional aid to control the livestock production.

Surveillance cameras can remotely monitor and be controlled from a PC, cell phone, or tablet. They also display

live images (black and white) in the dark using built-in IR light.

High-quality, long-lasting surveillance cameras can cope withthe harsh environment in the livestock houses.

Surveillance cameras are typically used for:

• Overview of production

Skilled labor in livestock production is a scarce resource. Surveillance cameras help control a larger number

of farms and houses through remote monitoring of animals and equipment, such as manure belts, feeding

systems, egg belts etc.

• Evaluation of the house climate

Surveillance cameras can be used to evaluate the distribution and behavior of the animals, indicating

whether the climate is optimal.

• Supervision of the farm personnel

In some regions, supervision of the farm personnel is a normal procedure. For example, do the personnel

stay in the right place at the right time and do what they are supposed to do. Surveillance cameras make

this job easier.

• Access control to the farm

Controlling the access of farm personnel, service engineers, veterinarians, feed trucks and others entering

the farm area is important to ensure a high level of biosecurity. Surveillance cameras support access con-

trol.

Surveillance Cameras

Technical User Guide 5

2 Product survey

130491 Surveillance camera Small 2MP/4xZ/PTZ/PoE

Is used for surveillance using images even in the dark using built-in IR light.

Surveillance camera Small ø131×102 mm can rotate 355 degrees, tilt up

and down and zoom in and out.

130492 Surveillance camera Large 2MP/25xZ/PTZ/PoE

Is used for surveillance using images even in the dark using built-in IR light.

Surveillance camera Large ø169×161 mm can rotate 360 degrees, tilt up

and down and zoom in and out.

Provides better images and has a higher zoom than 130491.

2.1 Accessories

301216 Network cable CAT6 shielded 0.5m

301217 Network cable CAT6 shielded 2 m

301218 Network cable CAT6 shielded 10 m

301219 Network cable CAT6 shielded 30 m

Surveillance Cameras

6 Technical User Guide

3 Mounting guide

3.1 Recommended tools

Below is a list of tools recommended for assembly.

Item Description

Cordless drill

Screwdriver bits

Drill kit

Crimp pliers

Controller

Multimeter

Utility knife

Side cutter

Pointed pliers

Screwdriver

Allen key kit

Ladder

Surveillance Cameras

Technical User Guide 7

3.2 Mounting the surveillance camera

If necessary, test the surveillance camera before

mounting, see section Setting up the surveillance cam-

era [}12].

Mount surveillance camera in the center of the ceiling,

or in the best viewing area.

Unscrew the bracket from the surveillance camera.

Mount the bracket on the ceiling with screws that can

hold the bracket in the ceiling.

Surveillance Cameras

8 Technical User Guide

4 Installation guide

4.1 Electrical connection

Installation, servicing and troubleshooting of all electrical equipment must be carried out by quali-

fied personnel in compliance with the applicable national and international standard EN 60204-1

and any other EU standards that are applicable in Europe.

The installation of a power supply isolator is required for each motor and power supply to facilitate

voltage-free work on the electrical equipment. The power supply isolator is not included.

4.1.1 Bandwidth requirements for the Internet connection

Note that gate 80.554 and 8000 in the firewall must be opened.

If the bandwidth is insufficient, the image quality and live streaming will be uneven.

Examples:

• Per stream 4 mbps.

For example, 2 cameras that display simultaneously on 2 devices use 4x2x2 = 16 mbps upload.

• Per stream 4 mbps.

For example, 3 cameras that display simultaneously on 1 device use 4x3x1 = 12 mbps upload.

4.1.2 Cabling

The LAN cables between switch and surveillance cameras must be cat5e or cat6 LAN cable.

Max. cable length 100 m for CAT5e and CAT6 cables.

4.1.3 Cable plan

Router

Internet LAN cable max. 100 m

LAN cable max. 100 m

Camera Camera

PoE switch

Surveillance Cameras

Technical User Guide 9

4.1.4 PoE switch

PoE switch is a box that provides both data transmission and power supply to the surveillance cameras and

data transmission to the PC.

• PoE switch (is not supplied by SKOV).

• SKOV recommends a PoE switch so that each surveillance camera only needs to be connected to one ca-

ble, namely a LAN cable.

• The 12 V power supply in the cardboard box for the surveillance camera is not to be used with the PoE

switch.

• Place the PoE switch in a protected environment where the PC is also located.

Surveillance camera requires the following PoE switch types to get enough power:

(130491) Small camera 9.2 W, requires minimum:

• IEEE802.3af (PoE) class 3 12.95 W

• IEEE802.3at (PoE+) class 3 12.95 W

• IEEE802.3bt (4PPoE) class 3 12.95 W

(130492) Large camera 18 W, requires minimum:

• IEEE802.3at (PoE+) class 4 25.5 W

• IEEE802.3bt (4PPoE) class 4 25.5 W

Surveillance Cameras

10 Technical User Guide

4.1.5 Connecting the LAN cable

If the RJ 45 plug to be connected to the surveillance

camera is with strain relief, it must be cut off to fit into

the waterproof end cap.

Mount a short RJ 45 plug on the LAN cable with a

crimp plier.

Mount nut, waterproof rubber gasket, and waterproof

end cap on the LAN cable.

Attach the O-ring gasket to the surveillance camera

plug.

Attach the waterproof end cap to the surveillance cam-

era plug.

Turn end cap to lock.

Mount the nut on the end cap.

Ready-mounted in waterproof housing.

Unused plugs and cable ends must be sealed with

the supplied self-amalgamating/waterproof black tape.

Pull the green terminal blocks out of the plugs.

Surveillance Cameras

Technical User Guide 11

Pull off backing of 15 cm tape.

Pull the tape out to 3 times the length so that it sticks.

Wrap the tape tightly around the plugs to obtain water-

proofing.

Press the tape firmly.

Surveillance Cameras

12 Technical User Guide

4.2 Setting up the surveillance camera

4.2.1 Credentials and IP Scheme

Before the setup, it is recommended to consider the following and complete the tables below.

4.2.1.1 iVMS4200 account

The iVMS4200 account is used if the iVMS4200 client/program is installed on a local PC.

Power user name Power user password

Power user security question

Number Questions Answer

4.2.1.2 Hik-connect account

The Hik- connect account is used if Hik-connect is used to stream on, e.g., a mobile device.

Hik-connect

user name

Hik-connect

password

Hik-connect

email address

4.2.1.3 Camera configuration

Camera configuration is used for configuration of the camera

Network Netmask Standard gateway

Camera name Admin password Hik-connect verification

code

IP address

Power user security questions for the camera

Number Questions Answer

For more information, see https://www.hikvision.com/europe/support/download/software/ivms4200-series/

Surveillance Cameras

Technical User Guide 13

4.2.2 Installing the iVMS4200 program

Download iVMS4200 from HikVision

https://www.hikvision.com/europe/support/download/

software/ivms4200-series/

Open the file.

Select Yes

Accept the license agreement.

Select Next.

Select Installer.

Select Finish.

Surveillance Cameras

14 Technical User Guide

4.2.3 Start-up of iVMS4200 user

Select Allow access for all processes.

Select Enable for upgrade detection.

Surveillance Cameras

Technical User Guide 15

Create a power user password, see section iVMS4200

account [}12] .

Select Log in.

Fill in all lines for power user security questions, see

section iVMS4200 account [}12].

Select Log in.

Select Set for automatic backup copy.

Set the required Auto Backup.

Select Save.

Select Yes.

Surveillance Cameras

16 Technical User Guide

have an account, see section Hik-connect account

[}12].

Select Send Message.

Enter the confirmation code received by email or SMS

message.

Select I have read and agree Terms of Service.

Select Register to register.

Select Close.

Check that the Hik-connect account is logged in.

Surveillance Cameras

Technical User Guide 17

4.2.4 Configure the iVMS4200 program

Select Device Management.

Select Online.

Select Allow access if this window appears.

Select the camera.

Select Activate.

Surveillance Cameras

18 Technical User Guide

Enter admin password, see section Camera configura-

tion [}12].

Enable Hik-Connect

Enter verification code.

Select OK.

Select whether you want a security question or email

address.

By Security Questions answer the 3 security ques-

tions, see section Camera configuration [}12].

Select OK.

Surveillance Cameras

Technical User Guide 19

By Email enter the email address to which the code

must be sent.

Select OK.

To set the IP address of the camera, select Modify

Network info (globe)

Enter IP address, Subnet Mask and Gateway, see

section Camera configuration [}12].

Scroll down.

Enter admin password, see section Camera configura-

tion [}12].

Select OK.

Surveillance Cameras

20 Technical User Guide

Select Add.

Select Hik-Connect.

Enter serial number, (or select Online Device, and se-

lect from the list).

Enter verification code, see section Camera configura-

tion [}12].

Select Add.

Check that camera is Online (green).

Select the main menu.

Select Main View.

Page is loading ...

Skov Surveillance cameras Technical User Guide

Brand: Skov

Model: Surveillance cameras

Type: Technical User Guide

This manual is also suitable for

130492

Download PDF

report

Skov Surveillance cameras Technical User Guide

This manual is also suitable for

Skov Surveillance cameras Technical User Guide

Related papers

Other documents