For Corner Sections Assembly:
Using the corner connector, align the two
fence sections perpendicular to each other,
and fasten the connectors onto the rails
using a screw driver or a power drill as
seen in Figure B.
Repeat for all corner section connections.
For Line Sections Assembly:
A continuous run can be achieved by
connecting sections to each other by
alternatively overlapping and fastening the
rails to each other, as shown in the Figures
C&D to the right.
Installation:
After all the sections are assembled
and connected to each other, apply gentle
pressure on the overlapping rails and
corners to push the sections into the
ground. If sections aren’t placed in the
right location, gently pull out the sections
and try again. A shortened custom-length
garden fence section can be made by
cutting off the excess rail lengths using a
hacksaw. Make sure a tall picket is placed
at the end of the rails.
NOTE:
The clearance between the short pickets and the ground is at the discretion of the installer. Also, after all the
sections have been assembled and installed into the ground, use the screw cover caps to cover up all exposed
screw tips on corner and line connections. Snip off any excess material from the caps using scissors.
CAUTION:
Although using a power drill may reduce assembly time, a high torque setting may snap or strip the screw
head. Use caution while assembling sections using power drills.