Assa Abloy HES KP20 User manual

Type
User manual

Assa Abloy HES KP20 is a stand-alone cabinet lock that can be used in various settings, including homes, offices, and businesses, to secure cabinets and other storage spaces. It features a keypad for entering passcodes, and it can be programmed with either a private mode (ongoing use) or a public mode (one-time use). The lock also has an emergency power option, which allows it to be unlocked with a standard 5-pin Micro USB cable in case the batteries run out.

Assa Abloy HES KP20 is a stand-alone cabinet lock that can be used in various settings, including homes, offices, and businesses, to secure cabinets and other storage spaces. It features a keypad for entering passcodes, and it can be programmed with either a private mode (ongoing use) or a public mode (one-time use). The lock also has an emergency power option, which allows it to be unlocked with a standard 5-pin Micro USB cable in case the batteries run out.

Instruction Manual
Public Mode (One -time Use)
b
Lock the door
Close the cabinet door and enter your passcode
a
Passcode length
How to configure
4 Digit
5 to 12 Digits
Press any four digits
Press + 5 to 12 Digits +
(ex : 1 2 3 4) (ex : 1 2 3 4) (ex : 1 2 3 4)
문을 열때
Private Mode (On-going Use)
Enter the registered pass code
Rotate the knob to the locked position
and open the door
a
b
문을 잠글
Close the door and turn the knob
to the locked position
a
Using the Master Code
Important Note
· Factory Master Code
“ 3 5 2 6 ”
Two code levels
Master
Code
User
Code
An existing user code is deleted
when a valid Master Code is
entered.
The User Code will need to be set
again during programming of
private mode.
Press + “Master Code” +
Beep-Beep-Beep-Beep-Beep-
- Listen for extended beep
- Unlock the lock with short beep 5x followed by 5x
flashing Red LED's
a
b
Rotate the knob to the unlocked position and
open the door.
- this is confirmed by three red flashes followed
by a standard beep ( Sol-Do~)
-this is confirmed by three yellow flashes followed
by a long beep (Do-Mi-Sol~)
b
Enter the passcode you used to lock the door
a
Rotate the knob to the unlocked position
and open the door
Flashes
3 times
Private Mode (On-going Use)
- when the knob is rotated to the locked position
the cabinet lock will lock in 3 seconds.
a
a
Rotate the knob to the locked position
a
a
b
(ex : # 3 5 2 6 #)
Emergency Power
d
a
c
b
Step 1
Step 2
a
b
b
c
d
Sol-Do~
Do-Mi-Sol~
Flashes
3 times
Do-Mi-Sol~
Flashes
3 times
Sol-Do~
St ep 1 Step 2
Do-Mi-Sol~
Flashes
5 times
Do-Mi-Sol~
Sol-Do
#
*
Connect a standard 5 pin Micro USB cable to
the USB port on the right side of the lock
When power is applied, both LED's flash
5x followed by an extended beep
Enter a valid User Code or Master Code to unlock
the cabinet
-An existing user code is deleted when a valid
Master Code is entered.
-The User Code will need to be set again during
programming of private mode.
Open the door and change the batteries
Package contents
Unlock the door Unlock the door Lock the door
a
Flashes
3 times
b
b
-this is confirmed by three yellow flashes followed
by a long beep (Do-Mi-Sol~)
One (1) HES KP20 cabinet lock
One (1) Rubber washer
One (1) M6 nut
One (1) Flat and one (1) Offset Locking Cam
Two (2) M4 washers
Five (5) Pan Head Phillips Screws
M4 x10mm locking cam screw
M4 x10mm (1-5mm thick door)
M4 x 20 mm (10-15mm thick door)
M4 x 25 mm (15-20mm thick door)
M4 x 30 mm (20-25mm thick door)
Public Mode (One-Time use)
- Previously used passcode will be erased
after unlock and stay open for next user.
1
2
3
4
5
6
6-1
6-2
Hardware installation
1
2
3
4
5
6-1
5
6-2
b
Ø13/64"
(5 mm)
Ø11/16"
(17 mm)
5-5/64" (129 mm)
Flashes
5 times
Installation Template
Caution
-Risk of explosion if battery is replaced
by an incorrect type.
-Please only use new alkaline batteries.
Power
: 4.5V (Alkaline AAA 1.5V x 3)
HES KP20 (12-button keypad) stand-alone cabinet lock
LED Feedback
-Red
-Yellow
-Amber
Audio Feedback
Short Beep - "Beep-"
Std. Beep - "Sol-Do~"
Long Beep - "Do-Mi-Sol~"
-this is confirmed by three red flashes followed
by a standard beep (Sol-Do~)
The cabinet lock will automatically lock in 3 seconds
b
Press for 4 secs.
ELECTRONIC SECURITRY HARDWARE
HES | Securitron
assaabloyesh.com | 800.626.7590 | 10027 S. 51
st
Street Phoenix, AZ 85044 USA
Change a User Code with a registered Master Code (Private Mode)
Press button for 4 secs
Enter registered Master Code
How to switch between Public & Private Mode
a
a
Beep~
- Flashing Yello w LED's f or 8
seconds followed by a short beep
Enter
Master Code
#
d
a
c
Ra-Si~
- Flashing Yello w LED's f or 8
seconds followed by a long beep
Enter new
User Code
Do-Re-Mi~
- 5x flashing Red LED's followed
by an extended beep
-New User Code successfully
registered
Change a User Code with a registered User Code
*
a
b
*
e
a
g
# (for 4 seconds)
3 5 2 6 #
3 3 3 3 #
· Master code : 3 5 2 6
· New User code : 3 3 3 3
a
a
1
a
+
#
문을 열때
문을 잠글
Turn on the sound
1
#
aa
Change the User Code
(for 4 sec s)
a
b
#
Step 1
(1 time)
* *
(1 time)
Beep~
(1 time)
*
#
#
Private Mode (On-going Use)
- when the knob is rotated to the locked position
the cabinet lock will lock in 3 seconds.
How to set other functions of HES KP20
#
#
Example)
예시 )
Example)
Enter registered Master Code; an existing user code is deleted when a valid Master Code is entered
Step 2 Step 3 Step 4 Step 5
Flashing
for 8 secs
Flashing
for 8 secs
Press button
#
Enter new User Code
Flashing
for 8 secs
Press button
#
Step 1 Step 2 Step 3 Step 4 Step 5
(for 4 sec s)
Beep~
Flashing
for 8 secs
- Flashing Yello w LED's f or 8
seconds followed by a short beep
Enter
User Code
Enter registered User Code
Ra-Si~
Flashing
for 8 secs
*
Press button
- Flashing Yello w LED's f or 8
seconds followed by a long beep
Enter new User Code
Enter
User Code
Do-Re-Mi~
Flashes
5 times
- 5x flashing Red LED's followed by
an ex tended beep
-New User Code successfully registered
· Current User code : 3 3 3 3
· New User code : 4 4 4 4
* (for 4 seconds)
3 3 3 3 *
4 4 4 4 *
Example)
How to turn Melody Sound On / Off
Step 1 Step 2
Step 3
Step 4 Step 5 Step 6 Step 7
Press button for 4 secs
#
- Flashing Yello w LED's f or 8
seconds followed by a short beep
Enter registered “Master Code”
Enter
“Master Code”
Flashing
for 8 secs
Ra-Si~
*
Press button
*
Press button
Enter new
“Master Code”
Enter new
“Master Code”
again
- Flashing Yello w LED's f or 8
seconds followed by a short beep
Enter new “Master Code”
Press button
- Flashing Yello w LED's f or 8
seconds followed by a short beep
Enter New “Master Code”
one more time
Press button
-5x flashing Red LED's followed by
an ex tended beep
-New Master Code successfully registered
· Current Master code : 3 5 2 6
· New Master code : 5 5 5 5
# (for 4 seconds) 3 5 2 6 * 5 5 5 5 # 5 5 5 5 #
Change the Master Code
Flashing
for 8 secs
#
(for 4 secs)
Ra- i~
Do-Re-Mi~
Flashing
for 8 secs
Flashes
5 times
Sol-Do~
Flashes
3 times
- 2x flashing Red LED's followed by a
long beep
- 3x flashing Yellow LED's followed by a
long beep
Flashes
3 times
Sol-Do~
(for 4 secs)
- 3x flashing Yellow LED's followed by a
long beep
Turn off the sound
Press , and buttons
simultaneously for 4 seconds
-2x flashing Red LED's followed by a
long beep
e
c
d
b
c
d
e
f
8
+
8
a
1
a
+
#
Ra-Si~
(for 4 secs)
8
+
1
#
Press , and buttons
simultaneously for 4 seconds
8
1
+
#
(for 4 secs)
0
+
1
#
Press , and buttons
simultaneously for 4 seconds
0
문을 열때
문을 잠글
Private Mode Public Mode
a
a
Sol-Do~
1
+
#
(for 4 secs)
0
+
a
1
#
Press , and buttons
simultaneously for 4 seconds
0
Flashes
2 times
Flashes
2 times
FCC statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
This appliance and its antenna must not be co-located or operation in conjunction with any other antenna or transmitter.
This equipment should be installed and operated with minimum distance 20cm between the radiator& your body.
#
(1 tim e)
(1 tim e)
#
Document #3080006.013 Rev. 1
  • Page 1 1
  • Page 2 2

Assa Abloy HES KP20 User manual

Type
User manual

Assa Abloy HES KP20 is a stand-alone cabinet lock that can be used in various settings, including homes, offices, and businesses, to secure cabinets and other storage spaces. It features a keypad for entering passcodes, and it can be programmed with either a private mode (ongoing use) or a public mode (one-time use). The lock also has an emergency power option, which allows it to be unlocked with a standard 5-pin Micro USB cable in case the batteries run out.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI