ASROCK SUSB 3.0 Quick Manual

ASRock USB 3.0 Card Quick GuideASRock USB 3.0 Card Quick Guide

ASRock USB 3.0 Card Quick Guide

I. IntroductionI. Introduction

I. Introduction

ASRock USB 3.0 Card allows you to enjoy the high speed data transfer rate up to

5.0 Gb/s, which is ten times faster than current USB 2.0 device (480 Mb/s). With

two USB 3.0 ports on ASRock USB 3.0 Card, you can have a more flexible option

to upgrade the USB data transfer rate for your motherboard. Therefore, on this

basis of the advantageous data transfer speed and the facilitating mobile

capability, USB 3.0 may replace other devices to become a trend for external

interface.

II. InstallationII. Installation

II. Installation

Before you install ASRock USB 3.0 Card on your motherboard, please refer to

below steps carefully.

Step 1. Insert ASRock USB 3.0 Card into PCIE slot on ASRock motherboard. Please

make sure to disconnect power supply before installing or removing

ASRock USB 3.0 Card.

Step 2. Boot your system and install ASRock USB 3.0 Card driver from ASRock

support CD. ASRock USB 3.0 driver is located in the following path of

ASRock support CD:

..\Drivers\USB3.0\NEC\Win7-64_Win7_Vista64_Vista_XP64_XP

(v10170)\NECEL-USB3-Host-Driver-10170-setup.exe

Step 3. Restart your system. Then you can freely enjoy the convenience of

ASRock USB 3.0 Card.

* Whether USB legacy can work depends on the system motherboard BIOS support.

USB 3.0 Ports:

Connect USB 3.0

devices to USB 3.0

ports.

3V_DUAL_POWER Jumper:

Short pin1, pin2 to enable USB Wakeup.

Short pin2, pin3 to disable USB Wakeup

to meet EuP standard.