Renkforce Control 150 Passive monitor speaker 9.3 cm 3.75 inch 20 Owner's manual

Brand: Renkforce

Model: Control 150 Passive monitor speaker 9.3 cm 3.75 inch 20

Category: Coffee making accessories

Type: Owner's manual

Page is loading ...

Installation/setup

Do not place the loudspeakers in the direct vicinity of TV sets or computer monitors.

There is the risk that the magnetic ﬁelds generated by the loudspeakers could distort

the picture.

When setting up the loudspeakers, make sure that they are on a stable footing and that

you ﬁnd a correspondingly stable set-up surface.

In case of wall mounting, make sure that the fastening is secure and that the fastening

elements can support the weight of the loudspeakers.

Loudspeakers falling from the wall may cause serious personal injury.

The monitor loudspeakers can be stood up, laid down or fastened to the ceiling using the provided

mounting brackets.

To achieve the best possible sound, attempt to implement the following suggestions for the posi-

tioning in your listening room, within the framework of your possibilities:

• Place the loudspeakers in locations that are as equidistant as possible to the location from

where you will be listening (equilateral triangle).

• In rectangular rooms, the loudspeakers should be set up along the short wall, if possible.

• The tweeters should be approximately at the height of your ears.

Experiment with your setup possibilities and also with the alignment of your loudspea-

kers a little to determine the best location in your listening room.

If you want to secure the loudspeakers on the wall using mounting brackets, proceed as follows:

• Use a mounting bracket as template and draw the mounting holes at the location of the mounting

site. Make sure that no cables or the like are damaged beneath the mounting area by drilling.

• If necessary, use dowels to screw tight the mounting bracket on the wall. The dowels and

screws have to be suitable for the mounting surface and be able to bear the weight of the

loudspeakers.

• Fasten the loudspeakers, using the enclosed screws, to the mounting bracket. Align the louds-

peakers in a way so that they are tilted towards the listening location.

Connection

When connecting the loudspeakers, make sure that the connecting cables are not

pinched or damaged by sharp edges.

The connection may only be made to suitable loudspeaker outputs on audio devices.

Make sure the impedance and power rating indicated in the technical data complies

with the data for the ampliﬁer connected. Otherwise the speakers or the ampliﬁer may

be damaged.

The ampliﬁer to which the loudspeakers are to be connected must be switched off

when you make the connections.

Lay the connection cables so they do not present a tripping hazard.

Connect the loudspeaker terminals on the rear of the boxes to the corresponding loudspeaker

outputs on the ampliﬁer.

• red connection or (+) > Positive loudspeaker output

• black connection or (-) > negative loudspeaker output

Pay attention to the loading capacity of the ampliﬁer. The total impedance for the connected loud-

speakers must not fall short of the minimum impedance for the ampliﬁer.

Disposal

Electrical and electronic equipment do not belong in the regular household waste.

Please dispose of the product, when it is no longer of use, according to the current

statutory requirements.

Technical data

Impedance ....................................................8 Ohm

Power rating (RMS/max.) ...........................20/50 W

Frequency range ..........................................70-20000 Hz

Noise pressure (1W/1m) .............................84 dB

Operating instructions

Monitor loudspeakers

Item no. 1276169

Intended use

The monitor loudspeakers are used to convert the electric output signals from audio ampliﬁers

into audible sound waves and are only licensed for connection to the loudspeaker outputs of such

devices.

The product may only be used indoors; never outdoors. Do not expose to moisture, for example in

bathrooms or similar spaces.

Any other use than the one described above may lead to damage to the loudspeakers and involves

other risks, such as short-circuits, ﬁre, etc.

No part of the product must be modiﬁed or rebuilt.

Always observe the safety instructions.

Safety instructions

The warranty will be void in the event of damage caused by failure to observe these

safety instructions! We do not assume liability for any resulting damage.

Nor do we assume liability for damage to property or personal injury caused by im-

proper use or failure to observe the safety instructions. The warranty will be null and

void in such cases.

The exclamation mark symbol indicates important information in these operating in-

structions. Prior to starting up the product read the entire operating instructions, they

contain important information on the correct operation.

• The unauthorized conversion and/or modiﬁcation of the product is not allowed because of

safety reasons.

• Make sure that the loudspeakers are put into operation correctly. Therefore, please follow the

operating instructions carefully.

• This product is not a toy, it is not suitable for children. Children are not aware of the potential

dangers when using electrical devices.

• Also observe the safety and operating instructions of any other devices that are connected to

this device.

• N

ever pour liquids over electrical devices and never place objects ﬁlled with liquid on top of them.

• Do not place naked ﬂames such as burning candles on top of the device.

• Do not store any magnetic storage media such as ﬂoppy disks, video tapes etc. in the proximity

of the loudspeakers, as the magnetic ﬁeld from the loudspeakers may corrupt the information

stored on the storage media.

• Do not listen to excessively loud music for long periods of time. This may damage your hearing.

• Do not expose the loudspeakers to high temperatures, strong vibrations, dripping or splashing

water.

• Only use the monitor loudspeakers in a moderate climate, and avoid a tropical environment.

• Do not leave packaging material lying around carelessly. It may become a dangerous plaything

for children.

• Please observe the additional safety instructions in the individual chapters of this ma nual.

• In commercial institutions, numerous laws and regulations, like e.g. the accident prevention re-

gulations of the Employer’s Liability Insurance Association for Electrical Systems and Operating

Materials are to be observed. You must, as user, inform yourself by the responsible authorities

and must comply with the current provisions and regulations.

• If in doubt about how to connect the device correctly, or should any questions arise that are not

answered in this operating manual, please contact our technical advisory service or another

specialist.

Product features

• 2-way system

• Bass reﬂex housing

• High load capacity

• Rugged plastic housing

• Mounting bracket for wall mounting provided

This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).

All rights including translation reserved. Reproduction by any method, e.g. photocopy, microﬁlming, or the capture in electronic data

processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited. This publication represent

the technical status at the time of printing.

Page is loading ...

Renkforce Control 150 Passive monitor speaker 9.3 cm 3.75 inch 20 Owner's manual

Brand: Renkforce

Model: Control 150 Passive monitor speaker 9.3 cm 3.75 inch 20

Category: Coffee making accessories

Type: Owner's manual

Download PDF

report

Renkforce Control 150 Passive monitor speaker 9.3 cm 3.75 inch 20 Owner's manual

Renkforce Control 150 Passive monitor speaker 9.3 cm 3.75 inch 20 Owner's manual

in other languages

Related papers

Other documents