Operating System Software
Installation guide
New Operating System Software for VRM 6200
B45.03.070822
How to perform the update
The files required for the update are stored as compressed data in a Zip file for free download
from. Once unpacked the files provide a so-called OS image which shall be copied to an empty
CD-ROM into its root directory
Note: Do not add, modify or delete any files
Please follow the below-mentioned steps:
§ Download the Zip file "B45-03-070822.zip" to the HDD of your computer
o Unzip the file into an empty folder
Note: Do not use other decompression software than WinZip since it may cause errors
§ If not already available, create MP3 files in a total capacity of min. 45MB
Note: Due to the very small file size of the OS image, the MP3 files are required to keep
VRM 6200 DVD drive spinning.
§ Insert an empty CD-ROM to your PC's CD-ROM writer
§ Start your CD burning software.
o Create a folder "MP3" in the root directory of the CD-ROM
o Copy the MP3 files into the folder "MP3"
o Copy the OS image files into the root directory of the CD-ROM
o Start burning
Note: Recommended writing speed = x8
Disc status = Close session
§ Power on VRM 6200 and insert the completed disc. The disc will now be read.
§ On appearance of the selection screen chose "MCU". The update process will start automatic.
Note: Do not turn off power! The unit will perform an auto-restart after approx. 2min.
§ After re-start, remove and re-insert disc.
§ On appearance of the selection screen chose "MPEG". The update process will start automatic.
Note: Do not turn off power! The unit will NOT perform an auto-restart
§ After approx. 3min. the "VDO Dayton" screen appears and stays. Now power-off VRM 6200.
§ Power on again and remove disc.
§ Power off again. The update is now finished!