Artcobell Alphabet Installation guide

02.12.15 | Rv3

ALPHABET | INSTALLATION INSTRUCTIONS

 Applicable Base Models:

ATT Tops

ATLI Leg Kits

1. Place the work surface upside down on a cardboard or carpeted surface to prevent finish from scratching

2. Align the leg assembly keyholes with the 4 shoulder screws as shown below in Figure 1.

3. With the I-Leg assembly now placed over the shoulder screws, slide the leg assembly in the direction indicated

below in Figure 2. (IMPORTANT – SEE NOTE ON REVERSE SIDE)

Under Seat Wire Book Basket

Table Tops and Leg Kits | I-Leg

Slide I-Leg Assembly

Start Position

Final Position

Figure 1

I-Leg Assembly Keyhole

Shoulder Screw

Figure 2

02.12.15 | Rv3

ALPHABET | INSTALLATION INSTRUCTIONS

NOTE: Some resistance sliding the I-Leg Assembly to its final position may be encountered. This should be

considered normal. Use of a plastic or leather mallet to aid assembly is permissible if used as shown

below in Figure 3.

4. Install the ¼-28 x 5/16” T-30, Torx head Lock Screw provided in the hardware kit with the T-30 Torx driver as

shown below in Figure 4.

5. Adjust leg to desired height. (Leg comes preset to a 29” table height)

Lock Screw

Figure 3

Figure 4

Use mallet here

Download PDF